Bottom Guard (Transmission) - Remove and Install
Removal Procedure
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
- Support transmission guard (2) with a suitable floor jack and cribbing.
Show/hide table
Illustration 1 | g00584798 |
- Remove eight bolts (1) and the washers.
- Use the floor jack to remove transmission guard (2). The weight of the transmission guard is 45 kg (100 lb).
Installation Procedure
- Use cribbing and a suitable floor jack to install transmission guard (2). The weight of the transmission guard is 45 kg (100 lb).
Show/hide table
Illustration 2 | g00584798 |
- Install eight bolts (1) and the washers. Remove the floor jack and cribbing.
End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
Caterpillar Information System:
994D Wheel Loader Machine System Tilt Cylinder - Disassemble
D8R Series II Track-Type Tractor Mirror
D7R Series II Track-Type Tractor Hydraulic System Ripper Control Valve
545 Wheel Skidder Cab Air Filter - Clean/Replace
D7R Series II Track-Type Tractor Hydraulic System Ripper Lift Cylinder
994D Wheel Loader Machine System Steering Cylinder - Assemble
545 Wheel Skidder Power Train Bottom Guard (Engine) - Remove and Install
613C Series II Wheel Tractor-Scraper Draft Arm Wear Plates - Check/Adjust
3408E and 3412E Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Camshaft
613C Series II Wheel Tractor-Scraper Differential and Final Drive Oil Level - Check
3408E and 3412E Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
515 Wheel Skidder and 525 Wheel Skidder Power Train Transmission
545 Wheel Skidder Power Train Bottom Guard (Front Axle) - Remove and Install
D7R Series II Track-Type Tractor Hydraulic System Bulldozer Tilt Control Valve
3034 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove
3408E and 3412E Engines for Caterpillar Built Machines Crankshaft - Remove
RA1.2, R1.4, R2.0, R2.2, R2.5, R2.7, R3.0, R4.5 and R5.5 Series Reduction Starting Motors Component - Test
D7R Series II Track-Type Tractor Hydraulic System Bulldozer Lift Control Valve
3500B Engines Accessory Drive (Upper Right Hand)
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Engine - Clean
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
994D Wheel Loader Machine System Tilt Cylinder - Assemble
992G, 992K, 994, 994D and 994F Wheel Loaders VIMS Loader Payload System Onboard Menu Operation