CID 0545 FMI 05 Ether Start Relay open/short to +batt
Conditions Which Generate This Code:
The Electronic Control Module (ECM) is attempting to energize the ether relay. The ECM detects an open circuit in the circuit for the ether relay.
System Response:
The ECM will log the diagnostic code.
The engine may be difficult to start.
Test Step 1. Perform the following diagnostic procedure: Ether Injection System - Test
Results:
- OK - STOP
Caterpillar Information System:
C27 and C32 Industrial and Petroleum Engines CID 1836 FMI 03 Auxiliary Temperature Sensor open/short to +batt
C11 and C13 Engines Flywheel
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Electronic Service Tools
C15 and C18 Engines for Caterpillar Built Machines Flywheel
C9 On-Highway Engines Fuel System
EMCP3 Analog Input Circuit Fault
EMCP3 Service Maintenance Interval Warning
EMCP3 Generator Undervoltage Warning
EMCP3 Generator Underfrequency Warning
UPS Firmware Version 3.13 and 3.14 Update{7620} UPS Firmware Version 3.13 and 3.14 Update{7620}
3500 Engines for Caterpillar Built Generator Sets Engine Oil Temperature Sensor
3500 Engines for Caterpillar Built Generator Sets Engine Coolant Temperature Sensor
C-12 Generator Set Engine CID 0545 FMI 06 Ether Start Relay short to ground
EMCP3 Charging System
3512B, 3512C, and 3516B Generator Set Engines with Dynamic Gas Blending Cylinder Head
C9 Engines for Caterpillar Built Machines Cooling System
EMCP3 Data Link Circuit Fault
3500 Generator Sets Fuel System Primary Filter (Water Separator) Element - Replace
3500 Generator Set Engines Valve System Components
C11 and C13 Engines Belt Tensioner
3500 Generator Set Engines Valve Lash - Adjust
C7 Urban Transit Bus Engines Welding on Engines with Electronic Controls
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
EMCP3 Digital Input Circuit Fault