Note: The numbers that are shown in the following illustrations indicate the required number of clockwise turns of the adjusting screw after the adjusting screw is turned to the maximum setting for the lubricant flow. One 360 degree turn of the adjusting screw is equal to approximately 0.10 cc (.006 cubic inch) of lubricant.
For additional information on adjusting the injectors, refer to the following section in this Service Manual, RENR2515, "Lubrication Injectors - Adjust".
 | |
| Illustration 1 | g00316665 |
View of the Articulation Joint (1) Engine end frame. (2) Non-engine end frame. | |
 | |
| Illustration 2 | g00329521 |
View A-A The number that is shown for each injector is the required number of clockwise turns of the adjusting screw. | |
 | |
| Illustration 3 | g00329520 |
View B-B | |
 | |
| Illustration 4 | g00337512 |
View C-C The number that is shown for each injector is the required number of clockwise turns of the adjusting screw. | |
 | |
| Illustration 5 | g00337513 |
View D-D The number that is shown for each injector is the required number of clockwise turns of the adjusting screw. | |
 | |
| Illustration 6 | g00329518 |
View of the Injector Bank for the Tilt Lever The number that is shown for each injector is the required number of clockwise turns of the adjusting screw. | |