627F Wheel Tractor-Scraper Caterpillar


Before Starting Engine

Usage:

627F 1DL
Start the engine only from the operator's compartment. Never short across the starter terminals or across the batteries. Shorting could bypass the engine neutral start system. Shorting could also damage the electrical system.

Inspect the condition of the seat belt and the condition of mounting hardware. Replace any damaged parts and any worn parts. Regardless of appearance, replace the seat belt after three years of use. Do not use a seat belt extension on a retractable seat belt.

Adjust the seat so that full pedal travel can be achieved when the operator's back is against the back of the seat.

Make sure that the machine is equipped with a lighting system that is adequate for the job conditions. Make sure that all lights are working properly.

Before you start the engine or before you move the machine, make sure that no one is on the machine, underneath the machine, or around the machine. Make sure that there are no personnel in the area.

Caterpillar Information System:

994D Wheel Loader Steering System Filter (Steering and Brake)
615C Series II Wheel Tractor-Scraper Mounting and Dismounting
938G Wheel Loader and IT38G Integrated Toolcarrier Secondary Steering
992G Wheel Loader Electrohydraulic System Piston Pump Cutoff Pressure (Variable Displacement) - Test and Adjust
966G and 972G Wheel Loaders Transmission Oil - Change
613C Series II Wheel Tractor 3116 Engine Supplement Air Conditioner Accumulator - Remove and Install
3524B Engines for 797 and 797B Off-Highway Trucks Electronic Control Module (ECM)
627F Wheel Tractor-Scraper Safety Messages
994 Wheel Loader Steering System Steering Control
994 Wheel Loader Braking System Service Brakes
992G Wheel Loader Electrohydraulic System Relief Valve Pressure (Line, Tilt Cylinder Head End, Left Valve Dump) - Test and Adjust
966G and 972G Wheel Loaders Hood Tilt Actuator - Lubricate
994D Wheel Loader Braking System Roller Switch (Stop Light)
992G Wheel Loader Electrohydraulic System Torque Converter Stall and Variable Displacement Pump Double Stall - Test
966G and 972G Wheel Loaders Transmission Oil Filter - Replace
992G Wheel Loader Electrohydraulic System Tilt Cylinder - Isolate for Drift Check
992G Wheel Loader Electrohydraulic System Ride Control Valve - Isolate for Drift Check
992G Wheel Loader Electrohydraulic System Torque Converter Stall (3FWD) - Test
623F Wheel Tractor-Scraper Machine Parking
992G Wheel Loader Electrohydraulic System Torque Converter Stall (1FWD) - Test
3500 Engines for Caterpillar Built Generator Sets Accessory Drive (Upper Right Hand)
3500B Engines Fuel Filter
627F Wheel Tractor-Scraper Sound Information and Vibration Information
621F Wheel Tractor-Scraper Model View Illustrations
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.