Correction to the Operation and Maintenance Manual, SEBU7641-01 {1102}
- Industrial Engine:
- 3054E (S/N: 3041-UP)
- 3056E (S/N: 3561-UP)
The Maintenance Interval Schedule in the Operation and Maintenance Manual, SEBU7641-01 for the 3054E and the 3056E engines has changed. It is no longer necessary to perform the "Engine Valve Lash-Inspect/Adjust" at the interval of "First 300 L (80 US gal)" of Fuel or First 20 to 40 Service Hours. The "Engine Valve Lash-Inspect/Adjust" should still be performed at "Every 1000 Service Hours". This is stated in the Operation and Maintenance Manual. This correction will be published in the next revision of the Operation and Maintenance Manual.
Caterpillar Information System:
Product Link - PL102C Configuration
C7 On-highway Engine Cylinder Block Cover Group
Product Link - PL102C System Schematic
G3500 Engines Engine Operation
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader Low Power/Poor or No Response to Throttle
3126B Petroleum Engine Engine Speed/Timing Sensor Circuit - Test
2004/05/01 A New Type of Main Bearing Is Now Used {1202, 1203}
2013/03/01 A New Type of Main Bearing is Now Used {1203}
3406E and 3456 Generator Set Engines Can Not Reach Top Engine RPM
2004/05/03 A New Type of Main Bearing is Available {1202, 1203}
3406E and 3456 Generator Set Engines Engine Speed/Timing Sensor - Calibrate
3406E and 3456 Generator Set Engines Engine Pressure Sensor - Calibrate
3406E, C-10 and C-12 On-highway Engines Eaton Top 2 Transmission Circuit - Test
C7 On-highway Engine Air Compressor
Product Link - PL102C Diagnostic Capabilities
C18 Marine Generator Set Aftercooler Condensate Drain Valve - Inspect/Clean
C7 Engines for Caterpillar Built Machines Vibration Damper
3126B Engine for Caterpillar Built Machines Connecting Rod
C27 and C32 Industrial and Petroleum Engines Fuel Transfer Pump
C15 Petroleum Engines Alternator - Remove and Install
3406E and 3456 Generator Set Engines E271 User Defined Switch Active
3500B Marine Propulsion Engines Engine Valve Lash - Inspect/Adjust
C7 Petroleum Engines Finding Top Center Position for No. 1 Piston
Product Link - PL102C Electronic Service Tool Does Not Communicate with ECM