Usage:
start by:
a) remove flywheel
b) remove starting motor
1. Loosen the bolts that hold the oil pan and oil pan plate to the cylinder block. Remove the bolts that hold the oil pan plate to the flywheel housing.
2. Fasten a hoist to the rear of the engine. Lift the rear of the engine and install shims on each side of the engine between the cylinder block and oil pan plate.
3. Install tooling (A) on the flywheel housing. Remove bolts (1) that hold the flywheel housing to the cylinder block.
4. Remove flywheel housing (2) from the engine. The weight of the flywheel housing is 85 lb. (39 kg).
Install Flywheel Housing
1. Clean the old gasket from the surfaces of the cylinder block and flywheel housing that make contact with each other. Install a new gasket on the cylinder block.
2. Install two 1/2"-13 NC guide bolts (1) in the cylinder block as shown. Install tooling (A) on the flywheel housing. Fasten a hoist and put the flywheel housing in position on the guide bolts. Install all but two bolts in the flywheel housing. Remove tooling (A) and guide bolts. Install the other two bolts.
3. Cut the bottom of the gasket even with the flywheel housing and cylinder block. Put 5H2471 Gasket Cement on the bottom of the gasket where the gasket makes contact with the gasket for the oil pan plate. Remove shims (2) from each side of the engine. Tighten all of the oil pan bolts. Install the bolts that hold the oil pan plate to the flywheel housing.
end by:
a) install starting motor
b) install flywheel