MID 018 - CID 0576 - FMI 02 Heinzmann Actuator not controlling position
产生此代码的情况:
发动机转速大于700 rpm。 实际作动器位置与理想作动器位置之差大于作动器最大行程的15%。
系统响应:
该诊断代码可以在数字诊断工具(DDT)、发动机控制模块(ECM)或卡特彼勒电子技师(Cat ET)上查看到。
排放将会受到不良影响。
测试步骤 1. 进行以下的诊断步骤: 燃料作动器
结果:
- OK - 停止
Caterpillar Information System:
G3500 Engines MID 018 - CID 0570 - FMI 11 Temperature Sensor Reading out of range
G3500 Engines MID 018 - CID 0565 - FMI 11 Shutdown Imminent Due To Missing Desired Speed Signal
G3500 Engines MID 018 - CID 0564 - FMI 02 Noisy Desired Speed Signal
G3500 Engines MID 018 - CID 0563 - FMI 11 Loss of Desired Speed Signal
G3500 Engines MID 018 - CID 0560 - FMI 02 Cat Data Link fault
G3500 Engines MID 018 - CID 0557 - FMI 11 Oxygen Sensor Calculated Offset out of range
G3500 Engines MID 018 - CID 0556 - FMI 11 Oxygen Sensor Calculated Gain out of range
G3500 Engines MID 018 - CID 0555 - FMI 02 Noisy Oxygen signal
C9 Marine Auxiliary and Generator Set Engines Plate Locations and Film Locations
G3500 Engines MID 018 - CID 0554 - FMI 11 Oxygen Signal missing during O2 calibration step
Federal Emissions Warranty Information General Information
C9 Marine Auxiliary and Generator Set Engines Safety Messages
G3500 Engines MID 018 - CID 0577 - FMI 11 Heinzmann Actuator Calculated Gain out of range
Federal Emissions Warranty Information Emissions Warranty Information
G3500 Engines MID 018 - CID 0578 - FMI 11 Heinzmann Actuator Calculated Offset out of range
G3500 Engines MID 018 - CID 0590 - FMI 12 Engine Control Module malfunction
G3500 Engines MID 018 - CID 0591 - FMI 12 EEPROM checksum fault or ECM not programmed
2004/03/15 Updated Fuel Tank Caps Are Now Available {1273}
C32 Marine Engine Engine Valve Lash - Inspect/Adjust
C32 Marine Engine Piston Ring Groove - Inspect
2003/12/22 Updated Fuel Tank Caps are Now Available {1273}
G3500 Engines Cat Data Link
EMCP3 Electronic Control Module (Engine) - Electronic Unit Injection (EUI) Engines Only
C9 Marine Auxiliary and Generator Set Engines Model View Illustrations