C-15, C-16, and C-18 Truck Engines Caterpillar


Cylinder Liner

Usage:

C-16 7CZ


Illustration 1g00288159

The following steps are for installing the cylinder liner into the cylinder block.

  1. Apply 5P-3975 Rubber Lubricant on the surfaces of the cylinder liner bore. Apply 5P-3975 Rubber Lubricant on the rubber seals on the lower part of the cylinder liner.

  2. Put the filler band completely in clean engine oil for a moment.

  3. Install the filler band (3) in the groove under the liner flange without delay.

  4. Install the liner in the bore immediately, before the filler band expands.

Table 1
Sales Model  Engine Serial Number  (1) Bore Inside Liner  (2) Flange Thickness of the Liner 
C-15  6NZ
9NZ 
137.185 ± 0.025 mm (5.4010 ± 0.0010 inch)  8.890 ± 0.020 mm (0.3500 ± 0.0008 inch) 
C-16  7CZ
W1A 
139.685 ± 0.025 mm (5.4994 ± 0.0010 inch)  8.890 ± 0.020 mm (0.3500 ± 0.0008 inch) 
C-18  CJP
MEP
MDP 
145.000 ± 0.025 mm (5.7087 ± 0.0010 inch)  8.890 ± 0.020 mm (0.3500 ± 0.0008 inch) 

The minimum flange thickness of the part that can be used again is the following value. ... 8.870 mm (0.3492 inch)

Note: Refer to Guideline For Reusable Parts, SEBF8068, "Cylinder Liners" for more information. Also, refer to Testing and Adjusting, "Cylinder Liner - Projection" for the procedure for inspecting the projection of the cylinder liners.

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.