Smart Idle Parameters
"蓄电池监测和发动机控制电压"
此参数用来确定电压切断点。 如果低于此切断点，发动机控制模块 (ECM) 将自动提高发动机怠速以维持理想的蓄电池电压。 该特性有助于延长蓄电池的寿命。 只有在车辆停止并且没有挂档时，发动机怠速才会提高。 如果这些条件不能满足，怠速将不会调整。 当发动机处在专门的 PTO 模式下运行时该特性不起作用（"PTO On/Off" 开关处于 ON 位置）。
对于 12 伏系统，推荐设定为 12.2 伏，对于 24 伏系统为 24.5 伏。
注: 该特性需要在 J1/P1 上安装一个空档开关。 端子 62（输入 12）。 只有当变速箱处于空档时才能提高发动机转速。
Show/hide table
| 最小值 | 最大值 | 缺省值 |
|---|---|---|
| 0 伏 | 25.5 伏 | 0 伏 |
Caterpillar Information System:
C11, C13 and C15 On-highway Engines Timer Parameters
C-10, C-12 and C-15 On-highway Engines Engine/Gear Parameters
C-10, C-12 and C-15 On-highway Engines Dedicated PTO Parameters
Alternator - Delco 27SI Capacitor - Test
G3520B Engines E860 Cyl #20 Exhaust Port Temp Deviating Low
G3520B Engines E859 Cyl #19 Exhaust Port Temp Deviating Low
G3520B Engines E858 Cyl #18 Exhaust Port Temp Deviating Low
G3520B Engines E857 Cyl #17 Exhaust Port Temp Deviating Low
G3520B Engines E840 Cyl #20 Exhaust Port Temp Deviating High
G3520B Engines E839 Cyl #19 Exhaust Port Temp Deviating High
G3520B Engines E838 Cyl #18 Exhaust Port Temp Deviating High
G3520B Engines E837 Cyl #17 Exhaust Port Temp Deviating High
C-10, C-12 and C-15 On-highway Engines Engine Monitoring Parameters
C-10, C-12 and C-15 On-highway Engines Maintenance Parameters
C-10, C-12 and C-15 On-highway Engines Trip Parameters
C-10, C-12 and C-15 On-highway Engines Input Selections
C-10, C-12 and C-15 On-highway Engines Output Selections
C-10, C-12 and C-15 On-highway Engines Data Link Parameters
C11, C13 and C15 On-highway Engines Driver Reward
C11, C13 and C15 On-highway Engines Vehicle Activity Report Parameters
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Aftercooler
3054E Industrial Engine Engine Design
G3520B Engines Analog Sensor Signal
C-10, C-12 and C-15 On-highway Engines Diagnostic Codes