Engine Oil Cooler
Show/hide table
 | |
| Illustration 1 | g00802516 |
(1) Engine oil cooler
Note: The engine oil cooler is used on turbocharged engines only.
(2) Tighten the adapter for the engine oil filter to the following torque. ... 57 N·m (42 lb ft)
Note: Put Loctite 270 on the threads of the adapter that go into the engine oil cooler.
Caterpillar Information System:
G3600 Engines Engine Governing - Adjust
G3600 Engines Cylinder Liner
Wabco Air Compressors Operation of the Air Compressor
3500B and 3500B High Displacement Generator Set Engines Emergency Stop Switch (EMS II)
G3600 Engines Ignition System
G3304 and G3306 Engines Engine Speed Sensor
2001/06/01 A New Electrical System Schematic Is Available For The Marine Monitoring System II And The Generator Monitoring System {1901, 7490}
Wabco Air Compressors Cooling of the Air Compressor
3054E and 3056E Industrial Engines Air Compressor Filter - Clean/Replace - If Equipped
G3600 Engines Fuel System
3034 Marine Engine Heat Exchanger - Test
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Component Descriptions
3034 Industrial Engine Breather Deflector
Wabco Air Compressors No Compression of Air (Unloaded)
SPT342 Truck Mounted Pumper Before Starting Engine
SPT342 Truck Mounted Pumper Starting the Engine
G3304 and G3306 Engines Gas Shutoff Valve
3406E and C15 Marine Engines Turbocharger - Install
3500B and 3500B High Displacement Generator Set Engines Starting Motor System (EMS II)
3034 Marine Engine Crankcase Breather
2001/06/01 New Software Is Available For The Engines That Follow {7620}
2001/06/01 Electronic Control Modules and Computer Viruses {7620}
3456 Generator Sets Caterpillar Monitoring System
3046 Engine for Caterpillar Built Machines Valve Depth - Inspect