Stick - 9.1 m (29.86 ft)
Show/hide table
Illustration 1 | g01442961 |
Note: All bores must be free of paint. Use the 5P-0960 Grease Cartridge in order to coat all bores for the pins, the stick, the upper frame, and the cylinder pin bores.
Show/hide table
Illustration 2 | g01442963 |
Section A-A |
(1) Lubricate the sealing lip of the four lip type seals lightly with a 5P-0960 Grease Cartridge.
(2) 228-5621 Sleeve Bearing
- Quantity ... 2
- Inside diameter ... 120.32 ± 0.04 mm (4.737 ± 0.002 inch)
- Outside diameter ... 140.260 ± 0.013 mm (5.5220 ± 0.0005 inch)
- Installation depth for the sleeve bearing ... 9.5 ± 0.8 mm (0.37 ± 0.03 inch)
- Inside diameter ... 120.32 ± 0.04 mm (4.737 ± 0.002 inch)
Show/hide table
Illustration 3 | g01442962 |
Section B-B |
(3) 222-8775 Sleeve Bearing
- Quantity ... 2
- Inside diameter ... 100.290 to 100.377 mm (3.9484 to 3.9518 inch)
- Outside diameter ... 116.230 ± 0.013 mm (4.5760 ± 0.0005 inch)
- Installation depth for the sleeve bearing ... 9.5 ± 0.8 mm (0.37 ± 0.03 inch)
- Inside diameter ... 100.290 to 100.377 mm (3.9484 to 3.9518 inch)
Show/hide table
Illustration 4 | g01442960 |
View C-C |
(4) 253-5374 Pin
- Pin diameter ... 99.85 ± 0.04 mm (3.931 ± 0.002 inch)
- Bore diameter for the pin ... 100.043 ± 0.043 mm (3.9387 ± 0.0017 inch)
Caterpillar Information System:
307D Excavator Travel Alarm - Test - If Equipped
307D Excavator Fuel Tank Water and Sediment - Drain
H35D S, H45D S, H55D S and H65D S Hydraulic Hammers Hydraulic Accumulator (Low Pressure) - Test and Charge
307D Excavator Fuel System Water Separator - Drain
307D Excavator Fuel System Primary Filter (Water Separator) Element - Replace
311D LRR Excavator Machine Systems Receiver Dryer (Refrigerant) - Remove and Install
307D Excavator Engine Oil and Filter - Change
307D Excavator Engine Oil Level - Check
311D LRR Excavator Engine Supplement Refrigerant Condenser - Remove and Install
307D Excavator Cooling System Coolant (ELC) - Change
311D LRR Excavator Engine Supplement Turbocharger - Remove and Install
311D LRR Excavator Engine Supplement Battery - Remove and Install
311D LRR Excavator Machine Systems Relief Valve (Pilot) - Remove and Install
307D Excavator Hydraulic System Oil - Change
311D LRR Excavator Machine Systems Oil Filter and Base - Remove and Install
307D Excavator Hydraulic System Oil Filter (Pilot) - Replace
2008/06/16 A New Holding Bracket for the Muffler Is Now Used {1062}
345C Material Handler Hydraulic System Cab Riser Hydraulic System - Hydraulic Cab Riser
307D Excavator Hydraulic System Oil Filter (Return) - Replace
307D Excavator Hydraulic System Oil Level - Check
307D Excavator Hydraulic Tank Screen - Clean
307D Excavator Radiator Core - Clean
307D Excavator Swing Gear - Lubricate
H35D S, H45D S, H55D S and H65D S Hydraulic Hammers Hydraulic Accumulator (High Pressure) - Test and Charge