311D LRR Excavator Engine Supplement Caterpillar


Refrigerant Condenser - Remove and Install

Usage:

311D LRR CLA

拆卸步骤

    ------ WARNING! ------

    接触制冷剂会使人受伤。

    此系统永远处于加压状态,即便发动机没有工作也是如此。 切勿让已加注制冷剂的系统受热。

    接触制冷剂会造成冻伤。 让手、脸避开有助于防止受伤。

    制冷管路打开时,须始终佩带护目镜,即便压力计显示系统中已经没有制冷剂,也须佩带。

    取下接头时务必小心谨慎。 慢慢地拧松接头。 如果此系统仍然有压力,请抽空系统,回收制冷剂,然后再拆下接头。

    通过点燃的香烟吸入制冷剂会导致人身伤害或死亡。

    通过点燃的香烟或其他抽烟方法吸入空调制冷气体,或吸入燃烧空调制冷气体形成的烟雾,都会导致人身伤害或死亡。

    维修空调时,或在任何可能存在制冷气体的情况下都不要抽烟。

    请先将机器移至平坦的地方,然后再对空调和加热系统进行检查。 把所有机具降到地面。 确保变速箱处于空档或停车位置,确保停车制动器接合。 让所有其他人员远离机器。


  1. 回收空调系统中的空调制冷剂。 请参阅维修手册, SENR5664, "使用 R-134a 制冷剂的空调与暖风系统",了解相关正确步骤。 有关正确的工具,请参阅专门出版物, NEDG2500, "空调工具"。



    图 1g01441433

  1. 打开机器左侧的检修门 (1) 。



    图 2g01442853

  1. 断开软管组件 (2) 和 (5) 。

  1. 拆卸螺栓 (3) 和 (4) 。



    图 3g01442856

  1. 拆下螺栓 (6) 和 (8) 。

  1. 拆下制冷剂冷凝器 (7) 。

安装步骤




    图 4g01442856

  1. 定位制冷剂冷凝器 (7) ,然后安装螺栓 (6) 和 (8) 。



    图 5g01442853

  1. 安装螺栓 (3) 和 (4) 。

  1. 连接软管组件 (2) 和 (5) 。



    图 6g01441433

  1. 关闭机器左侧的检修门 (1) 。
,,

End By: 加注空调系统。 请参阅 维修手册SENR5664"使用 R-134a 制冷剂的空调与暖风系统",了解相关正确步骤。 有关正确的工具,请参阅 专门出版物NEDG2500"空调工具"。

Caterpillar Information System:

307D Excavator Cooling System Coolant (ELC) - Change
311D LRR Excavator Engine Supplement Turbocharger - Remove and Install
311D LRR Excavator Engine Supplement Battery - Remove and Install
307D Excavator Circuit Breakers - Reset
311D LRR Excavator Engine Supplement Air Cleaner - Remove and Install
Procedure to Retrofit the 385B UHD Machines with the New Fore Boom Control Valve{5051, 5057, 5117, 5461} Procedure to Retrofit the 385B UHD Machines with the New Fore Boom Control Valve{5051, 5057, 5117, 5461}
Assembly Instructions for Installing The Air Mix Door {7304, 7320} Assembly Instructions for Installing The Air Mix Door {7304, 7320}
311D LRR Excavator Engine Supplement Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install
311D LRR Excavator Engine Supplement Fuel Filter and Water Separator Base - Remove and Install
311D LRR Excavator Engine Supplement Fuel Priming Pump - Remove and Install
Procedure for the Installation of an Accumulator Circuit for the Drive Motor Improves the Functionality of the Two-Speed Travel{5057, 5058, 5069, 5077, 5137} Procedure for the Installation of an Accumulator Circuit for the Drive Motor Improves the Functionality of the Two-Speed Travel{5057, 5058, 5069, 5077, 5137}
311D LRR Excavator Engine Supplement Alternator - Remove and Install
307D Excavator Engine Oil Level - Check
307D Excavator Engine Oil and Filter - Change
311D LRR Excavator Machine Systems Receiver Dryer (Refrigerant) - Remove and Install
307D Excavator Fuel System Primary Filter (Water Separator) Element - Replace
307D Excavator Fuel System Water Separator - Drain
H35D S, H45D S, H55D S and H65D S Hydraulic Hammers Hydraulic Accumulator (Low Pressure) - Test and Charge
307D Excavator Fuel Tank Water and Sediment - Drain
307D Excavator Travel Alarm - Test - If Equipped
345C Excavator and 345C Material Handler Machine System Specifications Stick - 9.1 m (29.86 ft)
311D LRR Excavator Machine Systems Relief Valve (Pilot) - Remove and Install
307D Excavator Hydraulic System Oil - Change
311D LRR Excavator Machine Systems Oil Filter and Base - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.