Stick Bearings and Seals - Install - Work Tool End
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
B | 4C-9634 | Puller Stud | 1 |
9U-6832 | Nut | 1 | |
1P-1839 | Bearing Puller Adapter | 1 | |
6V-0113 | Cylinder | 1 | |
9U-6600 | Hand Hydraulic Pump | 1 | |
C | 1P-0520 | Driver Gp | 1 |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Use Tooling (B) in order to install bearings (2) in stick (3).
Note: Make sure that bearings (2) are installed to a depth of
9.5 ± 0.8 mm (0.37 ± 0.03 inch) . - Use Tooling (C) in order to install lip seal (1) in stick (3). Repeat this Step for the other side of stick (3).
Show/hide table
Illustration 1 | g01252670 |
Show/hide table
Illustration 2 | g01252643 |
End By:
- Install the work tool linkage. Refer to Disassembly and Assembly, "Work Tool Linkage - Remove and Install".
Caterpillar Information System:
325D Material Handler Machine Systems Stick Bearings and Seals - Remove - Work Tool End
330D Excavator Machine Systems Stick Cylinder - Remove and Install
325D Material Handler Machine Systems Stick Bearings and Seals - Install - Boom End
325D Material Handler Machine Systems Stick Bearings and Seals - Remove - Boom End
321D LCR Excavator Receiver Dryer (Refrigerant) - Replace
325C MHPU Mobile Hydraulic Power Unit Engine Oil and Filter - Change
2007/09/03 New Buckets are Available for Certain Mini Hydraulic Excavators {6101, 6503}
323D MHPU Mobile Hydraulic Power Unit Machine System Specifications Air Conditioner Lines
320D Excavator Leaving the Machine
320D Excavator Additional Messages
320D Excavator Alternate Exit
319D Excavator Plate Locations and Film Locations
325D Material Handler Machine Systems Swivel - Remove
325D Material Handler Machine Systems Swivel - Install
325D Material Handler Machine Systems Swing Gear and Bearing - Remove
325D Material Handler Machine Systems Swing Gear and Bearing - Install
330D Excavator Machine Systems Sprocket - Remove and Install
321D LCR Excavator Engine Oil and Filter - Change
321D LCR Excavator Additional Messages
M313D, M315D, M316D, M318D and M322D Excavators and M316D MHPU Mobile Hydraulic Power Unit Electronic System Automatic Lubrication Function
325D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Specifications - 325D and 329D Ditch Cleaner
3176C, 3406E and 3456 Industrial Engines Exhaust System Contains Oil
330D Excavator Forest Machine C9 Engine Supplement Refrigerant Condenser and Fan Motor - Remove and Install
2007/04/23 Repair Procedure for Damaged Spillguards on Wheel Loader Buckets {6101, 6102, 7000}