Illustration 1 | g01381084 |
Illustration 2 | g01005382 |
Recommended operating pressure ...
Note: The operating pressure of the hammer will vary with the amount of back pressure, input flow, and the hardness of the material. The operating pressure of the hammer will be lower during operation against a harder material such as a steel plate. The operating pressure of the hammer will be higher during operation against a softer material such as rock or concrete.
(1) The change to the operating pressure with one complete turn of the screw (360° rotation) ...
Note: Operating pressure must be tested after the installation of the hammer onto the host machine. Refer to the Service Manual, "Pressure Control Valve (Operating Pressure) - Test and Adjust".
(2) Torque of the 116-7926 Housing ...
(3) Torque of the 116-8153 Guide ...
Note: Lubricate the moving parts and the seals with clean hydraulic fluid during assembly.
(A) Length of spring (4) under test ...
Note: Measure the free length of spring (4) while spool (5) is seated vertically on spring (4), and spring guide (6). Do not install valve housing (2).