Installation Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
5P-0306     |
Vacuum Transducer     |
1     |
FT-1115 |
Vacuum Cap     |
1     |
6V-4142 |
Fitting     |
1     |
5K-5068 |
Fitting     |
1     |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Note: Check the O-ring seals for wear or for damage. Replace the O-ring seals, if necessary.
Show/hide table
|
At operating temperature, the hydraulic oil tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Before installation or removal of any hydraulic test equipment, relieve the pressure in the hydraulic tank by slowly loosening the filler cap. |
|
Show/hide table
|
|
|
Illustration 1 | g01182971 |
- Install O-ring seals (10) onto relief valve assembly (8) .
Show/hide table
|
|
|
Illustration 2 | g01182970 |
- Install block (9) and relief valve assembly (8) .
Show/hide table
|
|
|
Illustration 3 | g01176822 |
- Install valve assembly (7) and bolts (6) .
Show/hide table
|
|
|
Illustration 4 | g01176821 |
- Connect harness assembly (5) .
Show/hide table
|
|
|
Illustration 5 | g01176820 |
- Connect hose assemblies (4) .
Show/hide table
|
|
|
Illustration 6 | g01176708 |
- Install bolts (3) .
Show/hide table
|
|
|
Illustration 7 | g01176706 |
- Install cover (2) .
Show/hide table
|
|
|
Illustration 8 | g00944947 |
- Remove Tooling (A). Install the cap onto the hydraulic tank.
Show/hide table
|
|
|
Illustration 9 | g01176704 |
- Open the access door to the main control valve. Turn valve (1) to the ON position.
- Fill the hydraulic system. Refer to Operation and Maintenance, "Hydraulic System Oil Level - Check". Refer to Operation and Maintenance, "Lubricant Viscosities and Refill Capacities".
End By:
Install the fuel tank. Refer to Disassembly and Assembly, "Fuel Tank - Remove and Install".