Electric Starting Motor - Remove and Install
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Place an index mark on all of the electrical wires that are connected to the electric starting motor. Disconnect the electrical wires from the electric starting motor.
- Fasten a suitable lifting device to the electric starting motor. The electric starting motor weighs approximately 27 kg (60 lb).
Show/hide table
 | |
| Illustration 1 | g00652039 |
- Remove three bolts (1) and the washers.
- Remove the electric starting motor.
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Fasten a suitable lifting device to the electric starting motor. The electric starting motor weighs approximately 27 kg (60 lb).
Show/hide table
| | |
| Illustration 2 | g00652039 |
- Position the electric starting motor in the flywheel housing. Install three bolts (1) and the washers.
- Connect all of the electrical wires to the electric starting motor by using the index marks.
Caterpillar Information System:
3126B Engine for Caterpillar Built Machines Coolant Temperature Is Too High
3524B Engines for 797 and 797B Off-Highway Trucks Valve Lash and Valve Bridge Adjustment
SR500 Generators Generator Description
Customer Communication Module (CCM) for Diesel Engines Communication Protocol for Customized Systems
3524B Engines for 797 and 797B Off-Highway Trucks Compression
On-Highway Engines Electronic PTO Installation and Application Guide General Information
SR500 Generators Bearing Temperature - Measure/Record
3618 Engine Cylinder Head - Assemble
3524B Engines for 797 and 797B Off-Highway Trucks Measuring Exhaust Temperature
3524B Engines for 797 and 797B Off-Highway Trucks Measuring Inlet Manifold Pressure
Customer Communication Module (CCM) for Diesel Engines General Specifications for Wire and Cable
3126B Marine Engine Auxiliary Water Pump - Assemble
SR500 Generators Rotating Rectifier - Test
3500B and 3500B High Displacement Generator Set Engines Engine Oil Pressure - Test
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Indicator for Engine Overspeed - Troubleshoot
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Troubleshooting Undiagnosed Problems
G3304 and G3306 Engines Exhaust Elbow
G3300 Engines Reference Information
3508B Engine for Caterpillar Built Machines Engine Oil Pressure is Low
3500 Engines For Caterpillar Built Power Modules Engine Oil Pressure is High
G3304 and G3306 Engines Excessive Bearing Wear - Inspect
G3500 Generator Sets Before Starting Engine
G3500 Generator Sets After Starting Engine
G3304 and G3306 Engines Increased Engine Oil Temperature - Inspect