CVP16, CVP40, CVP75 and CVP110 Vibratory Plate Compactors Caterpillar

Removal Procedure

Start By:

1. For the CVP40, remove the frame. Refer to the Service Manual, "Frame - Remove and Install".

Show/hide table



Illustration 1	g00847089
CVP40

1. It is important to mark hoses (2) and (3) for future installation for future installation onto gear motor (1) .

Note: Each hose on the CVP16, and CVP40 vibratory compactor has a coupling that attaches to the fittings on gear motor (1). Refer to Illustration 1.

Note: Each hose on the CVP75 and CVP110 vibratory compactors are connected to gear motor (1) by two half flanges, four bolts, and four washers. Check the O-rings for any wear or damage.

Show/hide table



Illustration 2	g00934198

2. Remove hose (2) from gear motor (1). Cap hose (2) in order to prevent contamination. Cap the fitting on the motor in order to prevent contamination.

Show/hide table



Illustration 3	g00934202

3. Remove hose (3) from gear motor (1). Cap hose (3) in order to prevent contamination. Cap the fitting on the motor in order to prevent contamination.
   Show/hide table

   Table 1

   Gear Motor
   Sales Model	Weight
   CVP16	7 kg (15 lb)
   CVP40	14 kg (31 lb)
   CVP75	31 kg (68 lb)
   CVP110	32 kg (71 lb)

Show/hide table



Illustration 4	g00847120

4. Remove two bolts (4) and the two washers in order to remove gear motor (1) .

Show/hide table



Illustration 5	g00934206

Note: The CVP16 motor is attached by two allen head bolts (4). It will be necessary to use an "8mm" allen wrench (6) with a ball end in order to remove the bolts.

5. Remove two bolts (4) and the two washers in order to remove gear motor (1) .

Show/hide table



Illustration 6	g00852340

6. Remove gear motor (1) from eccentric weight shaft (5). Refer to Table 1 for the weight of the gear motor.

Show/hide table



Illustration 7	g00847181

7. Remove O-ring (6) from the gear motor.

8. Remove lip seal (7) .

9. Inspect the splines on the shaft of the motor for wear.