1. Home
  2. Caterpillar
  3. Operation and Maintenance Manual
  4. #i01434062

322C Excavator Caterpillar


Engine Governor Oil Supply Screen - Clean/Inspect/Replace

Usage:

322C BFK

  • Unlatch the engine hood and raise the engine hood.
    Show/hide table
    Illustration 1g00102232

    Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.

  • Remove oil supply tube (1) from the side of the cylinder head. Remove fitting (2) and seal (3) from the rear of the governor housing.

  • Use a 6 mm hexagon wrench in order to remove oil screen (4).

  • Wash the oil screen in a clean, nonflammable solvent in order to remove any debris. Inspect the oil screen and the seals for damage. If necessary, replace the oil screen.

  • Install the oil screen into the governor housing. The oil screen should be far enough into the governor housing in order to allow clearance for the seals and for the fitting.

  • Install the seal, the fitting, and the oil supply tube.

  • Close the engine hood and latch the engine hood.

    • Caterpillar Information System:

    3406E and 3456 Engines for Caterpillar Built Machines Engine Oil Pan
    3408E and 3412E Engines for Caterpillar Built Machines Ether Injection System - Test
    307C Excavator Machine System Specifications Boom
    M325B Excavator Machine System Specifications Pilot Valve - Front Lines
    322C Excavator Engine Crankcase Breather - Clean
    307C Excavator Machine System Specifications Pilot Valve (Swing Boom)
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Cutting Edge
    3406E and 3456 Engines for Caterpillar Built Machines Engine Oil Pump
    M325B Excavator Machine System Specifications Cab Riser Wiring
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Cutting Edge
    307C Excavator Machine System Specifications Lines (Front) - Common Piping
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Cutting Edge
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Hydraulic Cylinder
    322C Excavator Engine Oil Level - Check
    M325B Excavator Machine System Specifications Lines (Heater)
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Hydraulic Cylinder
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Hydraulic Cylinder
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Hydraulic Cylinder
    M325B Excavator Machine System Specifications Lines (Travel Motor) - Upper
    322C Excavator Engine Oil and Filter - Change
    M325B Excavator Machine System Specifications Control Valve (Main)
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Speed Control Valve
    VHS-10, VHS-30, VHS-40, VHS-50, VHS-60 and VHS-70 Demolition and Scrap Shears Speed Control Valve
    325D and 329D Excavators Ether Starting Aid Cylinder - Replace - If Equipped
    Back to top
    Contacts My AVS
    The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
    CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.