Track Roller - Install
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 8S-7640     | Stand     | 2     |
8S-7611 | Tube     | 2     | |
8S-7615 | Pin     | 2     | |
B     | FT-1310     | Track Roller Lifting Fork     | 1     |
- Be sure that the mounting surfaces on the track roller, the track guide and the undercarriage frame are clean and free of dirt and debris prior to installing the track roller and the track guide.
- Use Tooling (B) to put track roller (2) in position on the undercarriage frame. The weight of the track roller is 34 kg (75 lb). Make sure that the plug in the roller is facing toward the outside of the undercarriage frame. Install the four bolts that hold the roller in position.
Show/hide table
Illustration 1 | g00367774 |
- Use Tooling (B) to put track guide (1) in position on the undercarriage frame. The weight of the track guide is approximately 50 kg (110 lb). Install the four bolts that hold the guide.
Show/hide table
Illustration 2 | g00367772 |
- Prior to lowering the machine to the ground and tightening the track, be sure that all of the track rollers rotate smoothly by hand.
- Lift the machine off Tooling (A) . Remove Tooling (A) from the machine. Lower the machine to the floor.
Show/hide table
Illustration 3 | g00367754 |
- Tighten the tension of the track. Refer to Operation and Maintenance Manual, "Tracks" for more information.
Caterpillar Information System:
315B Excavator Excavator Systems Track Roller - Assemble
302.5 Mini Hydraulic Excavator Cooling System Hoses - Inspect
315B Excavator Excavator Systems Track Roller - Disassemble
3176C and 3196 Industrial Engines Electronic Control Module - Remove and Install
A13 Auger Chain - Lubricate
315B Excavator Excavator Systems Track Carrier Roller - Assemble
A13 Auger Chain - Inspect/Adjust
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Gear - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Camshaft Gear - Remove and Install
5130 Excavator Hydraulic System Solenoid Valve (Bottom Dump)
5130 Excavator Hydraulic System Solenoid Valve (Swing Parking Brake)
3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Assemble
302.5 Mini Hydraulic Excavator Cooling System Coolant Level - Check
302.5 Mini Hydraulic Excavator Blade Linkage - Lubricate
302.5 Mini Hydraulic Excavator Fuel Tank Water and Sediment - Drain
5130 Excavator Hydraulic System Control Valve (Travel Parking Brake Dual Pressure)
320B Excavator Machine System Specifications Fuel Tank
320B Excavator Machine System Specifications Lines (Front)
315B Excavator Excavator Systems Track - Connect
315B Excavator Excavator Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove and Install
320B Excavator Machine System Specifications Lines (Front)
315B Excavator Excavator Systems Front Idler - Disassemble
3046 Engine For Caterpillar Built Machines Exhaust Manifold - Remove and Install
315B Excavator Excavator Systems Front Idler - Assemble