Prelubrication Oil Pump - Assemble
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 1P-0510 | 冲头总成 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 使用工具 (A) 将唇形密封件 (7) 安装到壳体 (4) 中。 在密封唇朝向内部时,安装内部唇形密封件。 在密封唇朝向外部时,安装外部唇形密封件。 将清洁的发动机机油涂抹在唇形密封件的密封唇上。
Show/hide table
图 2 g01291753 - 在转子 (6) 上涂抹干净的发动机机油。 将转子 (6) 安装在壳体 (4) 中。
Show/hide table
图 3 g01291754 - 在惰轮 (5) 上涂抹干净的发动机机油。 将惰轮 (5)安装到转子 (6)中。
Show/hide table
图 4 g01291758 - 安装原有的垫片 (8)。
- 将惰轮 (5)放好,以便头部件 (3)中的轴将接合惰轮。 对齐头部件和壳体 (4)上的标记。 安装头部件 (3)。
- 检查预润滑机油泵的端间隙。 测量转子后部和壳体底座加工面之间的间隙。 通过孔开口插入塞尺。 该端隙必须为
0.013 至 0.076 mm (0.0005 至 .0.0030 in) 。Show/hide table图 5 g01291760 - 如有必要,卸下缸盖。 增加或去掉垫片 (8),以获得正确的端隙。
Show/hide table
图 6 g00546236 - 对齐电机 (1)和泵 (2)上的标记。 将电机轴上的按键啮合到泵中的键槽中。
- 使两个装置结合到一起。 安装将两个装置固定在一起的螺栓。
Show/hide table
图 1 | g01291752 |
结束:
- 安装预润滑机油泵。 请参阅拆解和组装, "预润滑机油泵 - 安装"。
Caterpillar Information System:
3612 and 3616 Engines Prelubrication Oil Pump - Disassemble
Generator Set Load Sensor System Operation
3500B Locomotive Engines Overspeed Verify Switch
3612 and 3616 Engines Prelubrication Oil Pump - Install
3612 and 3616 Engines Prelubrication Oil Pump - Remove
3406E Truck Engine Inlet Manifold Pressure - Test
G3612 and G3616 Engines Prelubrication Oil Pump - Remove
3126B Marine Engine Monitoring System
3406E and 3456 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
3406E Generator Set Engines Self-Diagnostics
3500B Locomotive Engines Prelubrication System
G3612 and G3616 Engines Prelubrication Oil Pump - Install
G3612 and G3616 Engines Fuel Lines - Remove and Install
Generator Set Load Sensor Phasing - Check
G3612 and G3616 Engines Lubrication Metering Pump - Remove and Install
3612 and 3616 Engines Engine Oil Pump - Remove
3406E and 3456 Engines for Caterpillar Built Machines Fuel System - Prime
3500B Locomotive Engines Injector Solenoids
3034 Engine for Caterpillar Built Machines Engine Oil Pressure
3114, 3116 and 3126 Engines Fuel Transfer Pump
3176B Marine Engine Cold Weather Starting
3500B Locomotive Engines Start/Run/Stop Switch
Generator Set Load Sensor Engine Does Not Share Load - Troubleshoot
3408E and 3412E Engines for Caterpillar Built Machines Fuel System Pressure - Test