Prelubrication Oil Pump - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将以下部件在阀体 (7)上放好:阀 (8), 弹簧 (9) 和 销 (10)。 然后安装销子 (11)。
- 将阀组件安装到壳体 (12) 中。
Show/hide table
图 2 g00607984 气动预润滑泵 Show/hide table图 3 g00546101 电动润滑泵 Show/hide table图 4 g00607989 气动预润滑泵 - 将螺栓和单向阀 (3)安装在预润滑机油泵 (5)上。
- 将预润滑机油泵 (5)在发动机油底壳的支架上放好。 安装将预润滑机油泵固定入位的螺栓。
- 如有必要,安装弯管和管 (4)。
- 将管组件 (2) 连接至单向阀 (3)。
- 如有必要,连接线束组件 (6)。
- 如有必要,连接管组件 (1)。
- 向发动机油底壳加注机油以达到正确的液位。 请参阅操作和保养手册, "发动机机油 - 更换"。
Show/hide table
图 1 | g00546102 |
Show/hide table
弹簧压缩零件如果安装不当,会伤害人体。 为避免伤害,遵照出版的装配程序,并穿上保护装备。 |
Caterpillar Information System:
3612 and 3616 Engines Prelubrication Oil Pump - Remove
3406E Truck Engine Inlet Manifold Pressure - Test
G3612 and G3616 Engines Prelubrication Oil Pump - Remove
3126B Marine Engine Monitoring System
3406E and 3456 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
3406E Generator Set Engines Self-Diagnostics
3500B Locomotive Engines Prelubrication System
G3612 and G3616 Engines Prelubrication Oil Pump - Install
3126B Engine for Caterpillar Built Machines Unit Injector
3406E and 3456 Engines for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
3126 Truck Engine Main Bearing Journal
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Connecting Rod Bearing Journal
3500B Locomotive Engines Overspeed Verify Switch
Generator Set Load Sensor System Operation
3612 and 3616 Engines Prelubrication Oil Pump - Disassemble
3612 and 3616 Engines Prelubrication Oil Pump - Assemble
G3612 and G3616 Engines Fuel Lines - Remove and Install
Generator Set Load Sensor Phasing - Check
G3612 and G3616 Engines Lubrication Metering Pump - Remove and Install
3612 and 3616 Engines Engine Oil Pump - Remove
3406E and 3456 Engines for Caterpillar Built Machines Fuel System - Prime
3500B Locomotive Engines Injector Solenoids
3034 Engine for Caterpillar Built Machines Engine Oil Pressure
3114, 3116 and 3126 Engines Fuel Transfer Pump