G3408 and G3412 Engines Caterpillar


Alternator and Regulator

Usage:

G3408 6NB

6N-9294 Alternator




Illustration 1g00278489



Illustration 2g00278491

Voltage ... 24 V

Amperage ... 35 Amp

Note: Load the battery with a carbon pile 4C-4911 Battery Load Tester in order to get the maximum alternator output.

Polarity ... Negative ground

Rotation ... Either direction

The minimum full load current at 5000 rpm is the following value. ... 35 Amp

The minimum full load current at 1500 rpm is the following value. ... 11 Amp

Output voltage ... 27.5 ± 1.0 V

(1) Tighten the shaft nut to the following torque. ... 110 ± 10 N·m (80 ± 7 lb ft)

(2) Tighten the positive terminal nut to the following torque. ... 6.2 ± 0.6 N·m (55.0 ± 5.0 lb in)

(3) Tighten the ground terminal nut to the following torque. ... 2.25 ± 0.25 N·m (20 ± 2 lb in)

(4) Regulator

Voltage setting ... No adjustment

Permissible voltage range ... 27 to 29 V

Caterpillar Information System:

3034 Engine for Caterpillar Built Machines Housing (Front) - Install
3034 Engine for Caterpillar Built Machines Fuel Injection Pump - Install
G3408 and G3412 Engines Alternator and Regulator
3114, 3116 and 3126 Engines Coolant Temperature Below Normal
G3408 and G3412 Engines Flywheel Housing
G3612 and G3616 Engines Air Starting Motor - Install
3500B Engines Fuel Transfer Pump - Disassemble
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fan Drive
3500B Engines Fuel Transfer Pump - Remove
3500B Engines Fuel Priming Pump - Remove and Install
G3612 and G3616 Engines Air Starting Motor - Remove
3500B Engines Fuel Filter Housing - Install
G3408 and G3412 Engines Alternator and Regulator
G3408 and G3412 Engines Alternator and Regulator
G3612 and G3616 Engines Air Valve - Remove and Install
G3612 and G3616 Engines Actuator (Heinzman) - Remove and Install
G3612 and G3616 Engines Air Inlet Restriction Sensor - Remove and Install
G3612 and G3616 Engines Exhaust Manifold Shield - Remove and Install
3114, 3116 and 3126 Engines Engine Cranks but Will Not Start
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Accessory Drive - Splined
G3408 and G3412 Engines Magnetic Pickup
G3408 and G3412 Engines Magnetic Pickup
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0101 - FMI 13 Crankcase Pressure calibration required
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0110 - FMI 03 Engine Coolant Temperature open/short to +batt
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.