Housing (Front) - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Make sure that the mating surfaces of the front housing and the cylinder block are clean and free from damage.
- Put the gasket and front housing (8) in position on the engine.
Show/hide table
Illustration 1 | g00598948 |
- Install two nuts (7) and bolts (6) that fasten the front housing to the engine.
Note: The bolts for the front housing are different lengths and the bolts must be installed in the original location.
- Install bolts (5) in the back side of the front housing.
Show/hide table
Illustration 2 | g00598941 |
- Put plate (4) in position on the engine and install bolt (2) and four nuts (3) .
Show/hide table
Illustration 3 | g00595216 |
- Set the maximum fuel adjustment. Refer to the Testing and Adjusting Module, "Fuel Setting - Adjust" topic for more information.
- Connect return spring (1) to the throttle lever on the front housing.
Show/hide table
Illustration 4 | g00594914 |
End By:
- Install the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Install".
- Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
- Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Caterpillar Information System:
3034 Engine for Caterpillar Built Machines Fuel Injection Pump - Install
G3408 and G3412 Engines Alternator and Regulator
3114, 3116 and 3126 Engines Coolant Temperature Below Normal
G3408 and G3412 Engines Flywheel Housing
G3612 and G3616 Engines Air Starting Motor - Install
3500B Engines Fuel Transfer Pump - Disassemble
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fan Drive
3500B Engines Fuel Transfer Pump - Remove
3500B Engines Fuel Priming Pump - Remove and Install
G3612 and G3616 Engines Air Starting Motor - Remove
3500B Engines Fuel Filter Housing - Install
3500B Engines Fuel Filter Housing - Install - Spin-on Filters
G3408 and G3412 Engines Alternator and Regulator
G3408 and G3412 Engines Alternator and Regulator
G3408 and G3412 Engines Alternator and Regulator
G3612 and G3616 Engines Air Valve - Remove and Install
G3612 and G3616 Engines Actuator (Heinzman) - Remove and Install
G3612 and G3616 Engines Air Inlet Restriction Sensor - Remove and Install
G3612 and G3616 Engines Exhaust Manifold Shield - Remove and Install
3114, 3116 and 3126 Engines Engine Cranks but Will Not Start
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Accessory Drive - Splined
G3408 and G3412 Engines Magnetic Pickup
G3408 and G3412 Engines Magnetic Pickup
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0101 - FMI 13 Crankcase Pressure calibration required