3034 Engine for Caterpillar Built Machines Caterpillar

Installation Procedure

Show/hide table



Illustration 1	g00720291

1. Make sure that the mating surface of the fuel injection pump housing and fuel injection pump (12) are clean and free from debris.

2. Position the correct number of shims (14) on the fuel injection pump housing. Refer to the Specifications Module, "Fuel Injection Pump" topic for more information.

3. Ensure that pin (4) is aligned with the notch in shims (14) and the notch in the cylinder block. Align dowels (15) with fuel injection pump (12). Put fuel injection pump (12) in position on the engine.

Show/hide table



Illustration 2	g00720284

4. Install nuts (11) and bolts (10) that secure the fuel injection pump to the engine. Tighten nuts (11) and bolts (10) evenly to a torque of 22 N·m (16 lb ft).

Show/hide table



Illustration 3	g00720275

5. Install governor control linkage (9) onto pin (4) .

Show/hide table



Illustration 4	g00720270

6. Install spring (6) in the groove in pin (4) .

Show/hide table



Illustration 5	g00720261

7. Install spring (5) into the groove in pin (4) .

Show/hide table



Illustration 6	g00599562

8. Clean the mating surface of plate (3) and the cylinder block.

9. Put plate (3) in position on the engine and install bolts (1).

10. Remove the caps and the plugs from fuel lines (2) and install the fuel lines on the engine.

End By:

1. Install the fuel shutoff solenoid. Refer to Disassembly and Assembly, "Fuel Shutoff Solenoid - Remove and Install".
2. Install the air inlet manifold. Refer to Disassembly and Assembly, " Inlet Manifold - Install".