Crankshaft Front Seal - Install
Installation Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| C | 5P-3537 | Seal Guide | 1 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean housing (3) for crankshaft front seal (2) and inspect the housing for any damage.
Show/hide table
 | |
| Illustration 1 | g01037829 |
- Lubricate the lip of crankshaft front seal (2) with clean engine oil.
- Position crankshaft front seal (2) in housing (3) for the crankshaft front seal.
- Use Tooling (C) to install new crankshaft front seal (2) .
Show/hide table
| NOTICE |
|---|
Ensure that the lip of the crankshaft front seal that is spring loaded is facing toward the inside of the front housing and that it is square with the bore of the housing for the crankshaft front seal. |
- Apply clean engine oil on the area of the crankshaft pulley that will be in contact with crankshaft front seal (2) .
End By: Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Caterpillar Information System:
3176B Industrial Engine Model View Illustrations
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Front) - Install
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Front) - Remove
3114, 3116 and 3126 MUI Engine Governors Governor (Type V) - Disassemble
365B and 365B Series II Excavators Hydraulic System Swivel
3412E, C30 and C32 Marine Engines Housing (Front) - Install
3176C and 3196 Engines for Caterpillar Built Machines Electronic Unit Injector - Test
C18 Marine Generator Set Rotating Rectifier - Check
SR4 HV and SR4B HV Generators Space Heater - Check
SR4 HV and SR4B HV Generators Electrical Connections - Check
SR4 HV and SR4B HV Generators Stator Lead - Check
SR4 HV and SR4B HV Generators Generator Set Vibration - Inspect
G3500 Engines Crankshaft - Remove
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Governor
3054, 3054B and 3056 Marine Engines Marine Transmission Oil
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Remove
G3500 Engines Crankshaft - Install
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Injection Control Linkage
3126 Truck Engine (Military) Exhaust Brake
3612 and 3616 Engines Exhaust Manifold
3176C and 3196 Engines for Caterpillar Built Machines Air Inlet and Exhaust System - Inspect
3034 Engine for Caterpillar Built Machines Alternator - Remove and Install
3612 and 3616 Engines Exhaust Manifold