Air Starting Motor
Show/hide table
Illustration 1 | g00281423 |
(1) Cover
Tighten the bolts evenly in small increases until the following torque is reached. ... 80 N·m (60 lb ft)
(2) Torque for bolts ... 36 N·m (26 lb ft)
(3) Torque for bolts ... 78 N·m (55 lb ft)
(4) Tighten the bolt that holds the pinion to the following torque. ... 110 N·m (80 lb ft)
(5) Tighten the rotor clamp nut until the following clearance between the rear end plate and the rotor is reached. ... 0.03 to 0.08 mm (.001 to .003 inch)
Check the clearance again after the bolt for the rotor clamp nut is tightened.
(6) Tighten the bolt that holds the rotor to the following torque. ... 120 N·m (90 lb ft)
Caterpillar Information System:
3606 and 3608 Engines Turbocharger
3612 and 3616 Engines Turbocharger
3176C Engine General Information
G3300 Engines Standby Generator Set Maintenance Recommendations
3408B and 3408C Industrial and Marine Engines Auxiliary Drive Pulley
3176C Engine Engine Design
3176C Engine Reference Material
3408E and 3412E Engines for Caterpillar Built Machines Alternator Mounting
3408C and 3412C Marine Engines Magnetic Pickup
3612 and 3616 Engines Air Inlet Shutoff
3606 and 3608 Engines Stub Shaft (Front)
3612 and 3616 Engines Stub Shaft (Front)
3606 and 3608 Engines Engine Oil Cooler
3412E and C30 Engines Air Starting Motor Pressure Regulating Valve
G3300 Engines Automatic Start/Stop - Inspect - Generator Set
G3300 Engines Battery Charger - Check
3412E, C30 and C32 Marine Engines Aftercooler - Install
3126B Marine Engine Boost Pressure Sensor
3412E and C30 Marine Engines Zinc Rods - Inspect/Replace
G3300 Engines Batteries - Replace
G3300 Engines Belts - Replace
G3408 and G3412 Engines Camshaft
3304B and 3306B Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
G3300 Engines Carburetor - Inspect/Recondition