Housing (Front)
Show/hide table
图 1 | g01140255 |
(1) 螺柱 |
(2) 在缸体、前壳体和油底壳之间涂抹一层密封胶以便填补接合缝隙。
Show/hide table
图 2 | g01632995 |
注: 用清洁的发动机机油稍微润滑转速传感器总成的 O 形密封圈。
(3) 两个转速传感器总成的扭矩 ... 40 ± 5 N·m (30 ± 4 lb ft)
注: 组装期间,前壳体的后端面和缸体的前端面必须没有污染物。 组装过程中飞轮壳体总成的密封垫上必须没有污染物。
(4) 组装后必须修整前壳体的密封垫,以便使密封垫平齐。
Show/hide table
图 3 | g01140263 |
使用以下步骤来拧紧壳体的支架。
- 拧紧螺栓 1 和螺栓 2 至扭矩为 5 ± 3 N·m (45 ± 27 lb in)。
- 拧紧螺栓 3 和螺栓 6 至扭矩为 47 ± 9 N·m (35 ± 7 lb ft)。
- 拧紧螺栓 1 和螺栓 2 至扭矩为 47 ± 9 N·m (35 ± 7 lb ft)。
Caterpillar Information System:
3406E On-Highway Engine Pistons and Connecting Rods - Assemble
3412E and C30 Engines Engine Oil Pan
3306B Industrial Engine Engine Oil Pressure Switch
3306B Industrial Engine Engine Oil Pressure Switch
3306B Industrial Engine Coolant Temperature Switch
3408E and 3412E Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
C-10 and C-12 Industrial Engines Fuel Pressure Sensor
3306B Industrial Engine Engine Oil Pressure Switch
3408E and 3412E Industrial Engines Fuel Temperature Sensor
3408E and 3412E Industrial Engines Coolant Temperature Sensor
3306B Industrial Engine Coolant Temperature Sender
3408E and 3412E Engines for Caterpillar Built Machines Speed/Timing Sensor
3114, 3116 and 3126 MUI Engine Governors Governor Speed Circuit
3412C Engine Pistons and Connecting Rods - Install
3408E and 3412E Industrial Engines Gear Group (Front)
3306B Industrial Engine Engine Oil Pressure Switch
G3606 and G3608 Engines Reference Material
TK711, TK721, TK722 and TK732 Track Feller Bunchers Battery - Recycle
3306B Industrial Engine Ammeter
Charging System Troubleshooting {1406} Charging System Troubleshooting {1406}
3412E and C30 Engines Engine Support (Front)
Gas Engine Driven Chiller Driveline Troubleshooting
3306B Industrial Engine Governor Control
Gas Engine Driven Chiller Driveline Performance Log