Governor (Type IV)
Show/hide table
 | |
| Illustration 1 | g00519873 |
Typical Type IV Governor (1) Type II throttle (2) Fuel ratio control | |
The type code for the Type IV governor is "A", "0", or "1". These governors are also known as 2.3 Gain Governors.
Note: The term "2.3 Gain" refers to the ratio between riser travel and output shaft travel.
Caterpillar Information System:
3306B Industrial Engine Air Starting Motor
3114, 3116 and 3126 MUI Engine Governors Governor (Type III)
3114, 3116 and 3126 MUI Engine Governors Governor (Type II)
G3304 and G3306 Engines Electric Starting Motor
3114, 3116 and 3126 MUI Engine Governors Governor (Type I)
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft - Install
3406E Truck Engine Glossary of Electronic Control Terms
3114, 3116 and 3126 MUI Engine Governors Governor Identification - Introduction
3408E and 3412E Engines for Caterpillar Built Machines Fuel Filter Base
3306B Industrial Engine Crankshaft - Remove
3304B and 3306B Engines for Caterpillar Built Machines Connecting Rod Bearings - Install
3406E On-Highway Engine Crankshaft Main Bearings - Remove
3114, 3116 and 3126 MUI Engine Governors Governor (Type V)
3114, 3116 and 3126 MUI Engine Governors Governor (Type VI)
3114, 3116 and 3126 MUI Engine Governors Specification
3114, 3116 and 3126 MUI Engine Governors Governor Performance Data
3406C Engines for Caterpillar Built Machines Cylinder Block
3306B Industrial Engine Shutoff Solenoid
3306B Industrial Engine Magnetic Pickup
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3408E and 3412E Engines for Caterpillar Built Machines Cylinder Liner - Remove
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
3406C (PEEC III) Truck Engine Connecting Rod