Illustration 1 | g06196052 |
ECM Output Components (1) Left Rear Leg Lower Solenoid (2) Left Rear Leg Raise Solenoid (3) Right Rear Leg Lower Solenoid (4) Right Rear Leg Raise Solenoid (5) Front Legs Lower Solenoid (6) Front Legs Raise Solenoid (7) Conveyor Drive Forward Solenoid (8) Conveyor Drive Reverse Solenoid (9) Engine Cooling Fan Solenoid #2 (10) Front Steer Left Solenoid (11) Front Steer Right Solenoid (12) Rear Steer Left Solenoid (13) Rear Steer Right Solenoid (14) Moldboard Pressure Control (Down) Solenoid (15) Moldboard Lift Solenoid (16) Moldboard Boost Pressure Solenoid (17) Moldboard Float Solenoid (18) Power Distribution Module (19) Drive Pump #1 Forward Control Solenoid (20) Drive Pump #1 Reverse Control Solenoid (21) Propel Equal Flow Divider Solenoid (22) Propel Mode Shift Solenoid (23) Right Rear Leg Swing In Control Solenoid (24) Right Rear Leg Swing Out Control Solenoid (25) Rotor Belt Tension Solenoid (26) Rotor Clutch Solenoid (27) Water Spray Pump Forward Control Solenoid (28) Right Side Plate Float Solenoid (29) Right Side Plate Lower Solenoid (30) Right Side Plate Raise Solenoid (31) Left Side Plate Raise Solenoid (32) Left Side Plate Lower Solenoid (33) Left Side Plate Float Solenoid |
Each ECM will use output circuits to send electrical control signals to the output components. The output signals can create an action or the output signals can provide information to the ECM. The ECM will use different types of output signals to control the system components. Following are the types of output signals:
- PWM proportional driver
- "ON/OFF" driver
- Sinking driver
- Sensor power supply
- Data link
The ECM monitors the circuits of the output components. If the ECM determines that an abnormal condition exists in one of the circuits, the ECM will log a diagnostic code for the involved component.
The Legs Solenoids are driven by the following outputs from the Machine ECM:
- Left Rear Lower - Pin J1-48
- Left Rear Raise - Pin J1-49
- Right Rear Lower - Pin J1-51
- Right Rear Raise - Pin J1-52
- Front Lower - Pin J2–2
- Front Raise - Pin J2–3
Forward (7), Reverse (8) Conveyor Drive Solenoids
The Conveyor Swing Speed Solenoid is driven by output from the Machine ECM Pin J1-61.
- Forward Conveyor Drive - Pin J1-58
- Reverse Conveyor Drive - Pin J1-59
Engine Cooling Fan Solenoid #2 (9)
The Engine Cooling Fan Solenoid #2 is driven by output from the Machine ECM Pin J1-61.
Front Left (10), Front Right (11), Rear Left (12), Rear Right (13) Steer Solenoids
The Steering Solenoids are driven by the following outputs from the Machine ECM:
- Front Left - Pin J1-65
- Front Right - J1-66
- Rear Left - J1-67
- Rear Right - J1-68
Pressure Control (14), Lift (15), Boost Pressure Control (16), Float (17) Moldboard Solenoids
The Moldboard Solenoids are driven by the following outputs from the Machine ECM:
- Pressure Control - Pin J1–62
- Lift - Pin J2-5
- Boost Pressure - Pin J2-6
- Float - Pin J2-7
Forward (19), Reverse (20) Drive Pump #1 Control Solenoids
The Drive Pump #1 Solenoids are driven by output from the Transmission ECM
- Forward - Pin J1-48
- Reverse - Pin J1-49
Equal Flow Divider (21), Mode Shift (22) Propel Solenoids
The Propel Solenoids are driven by outputs from the Transmission ECM.
- Equal Flow Divider - Pin J1-51
- Mode Shift - Pin J1-52
Right Rear In (23), Right Rear Out (24) Leg Swing Solenoids
The Leg Swing Solenoids are driven by the following outputs from the Transmission ECM:
- Right Rear In - Pin J1-58
- Right Rear Out - Pin J1-59
Belt Tension (25), Clutch (26) Rotor Solenoids
The Rotor Solenoids are driven by the following outputs from the Transmission ECM:
- Belt Tension - Pin J1-67
- Clutch - Pin J1-66
Water Spray Pump Forward Control Solenoid (27)
The Water Spray Pump Forward Control Solenoid is driven by output from the Transmission ECM Pin J1-68
The Side Plate Solenoids are driven by output from the Transmission ECM
- Right Raise - J1-12
- Right Float - J2-3
- Right Lower - J2-2
- Left Raise - J2-5
- Left Lower - J2-6
- Left Float - J2-7
Power Distribution Module (18)
Outputs from the Machine ECM, Transmission ECM, and Steering ECM all drive components of the Power Distribution Module. There are no diagnostics for the module.