Engine Oil and Filter - Change
运转机器以使机油变热。 排放机油前,停下发动机。 机油变热后,废渣悬浮在机油中。 废渣将会随着机油一起排出。
机油变冷时,废渣在油底壳的底部沉积。 油温太冷时,废渣将不能排出。
如果不按建议的步骤去做,废渣可能会再次通过发动机的润滑系统循环。
- 打开发动机室。
- 拆下机器下面的检修板。
Show/hide table
图 1 g03783312 - 在连接到阀门 (1) 的排放软管下放置一个适当的容器。 有关溢出液体盛放的信息,请参阅操作和保养手册, "一般危险信息"。
- 打开排放阀 (1) 排放机油。
- 排放机油。
- 关闭排放阀。
Show/hide table
图 2 g06155958 - 拆下滤清器滤芯 (4)。 废置用过的滤芯。
- 清洁滤清器壳体底座。 必须从滤清器壳体底座上拆下所有旧滤清器密封。
- 在新的滤芯密封件上涂抹一薄层发动机机油。
- 用手安装新滤清器。 当密封圈接触基座时,将滤芯继续紧固3/4圈。
每个新机油滤清器上有间隔 90 度的旋转指示标记。 按指示的标记旋紧机油滤清器。
- 卸加润滑油加注口塞 (2)。 用新机油加注曲轴箱。 参考操作和保养手册, "加注容量"。 请参考操作和保养手册, "润滑剂粘度"。 清洁并安装机油加注口盖。
- 起动发动机前,检查油尺 (3) 的机油油位。 油位必须在油尺上的满范围标记内。
- 起动发动机。 运转发动机 2 分钟。 检查机器有无泄漏。 停下机器。
- 等待 10 分钟,使机油流回到曲轴箱中。 检查机油油位。 保持油位在油尺上的满范围标记内。
- 关闭发动机室。
Caterpillar Information System:
C7.1 Engines and Generator Sets Shutdown (Ground Level) - Test
785G Off-Highway Truck Machines Systems Temperature Sensor - Remove and Install - Recirculation
521B and 522B Track Feller Bunchers Tilt Linkage Bearings - Lubricate
CS44B and CP44B Vibratory Soil Compactors Engine Oil Sample - Obtain
Improved Thrust Washer and Wheel Bearing Retainer Now Used on Certain R1700G Load Haul Dump Machines {4050, 4201} Improved Thrust Washer and Wheel Bearing Retainer Now Used on Certain R1700G Load Haul Dump Machines {4050, 4201}
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Visual Service Procedure (VSP) Usage Guide
CS44B and CP44B Vibratory Soil Compactors Engine Oil Level - Check
The Mirror Post in the Handrail Assembly Has Been Updated on Certain793F Off-Highway Trucks {7319} The Mirror Post in the Handrail Assembly Has Been Updated on Certain793F Off-Highway Trucks {7319}
Truck Bodies May Experience Cracking in the Weld Between the Front Wall and Horizontal Rib on Certain 793 and 793F Off-Highway Trucks {7250, 7258} Truck Bodies May Experience Cracking in the Weld Between the Front Wall and Horizontal Rib on Certain 793 and 793F Off-Highway Trucks {7250, 7258}
MH3037 Material Handler Machine Systems Swing Drive - Assemble
MH3037 Material Handler Machine Systems Swing Drive - Disassemble
994K Wheel Loader Machine Systems Relief Valve (Hydraulic Oil Cooler Bypass) (Steering, Brake Oil Cooler Bypass) - Remove and Install
C7.1 Engines and Generator Sets Solenoid Valve - Test
New Pin Assembly in Hopper Cylinder and Mounting Group Is Now Used on Certain Pavers {7562} New Pin Assembly in Hopper Cylinder and Mounting Group Is Now Used on Certain Pavers {7562}
521B and 522B Track Feller Bunchers Hydraulic System Oil - Change
New Procedures for Updating the Stringer Rail Are Available on Certain 793D and 793F Off-Highway Trucks {0679, 7250, 7258} New Procedures for Updating the Stringer Rail Are Available on Certain 793D and 793F Off-Highway Trucks {0679, 7250, 7258}
CS44B and CP44B Vibratory Soil Compactors Fuel System - Prime
Consolidation of C175 Machine Engine Arrangements {1000} Consolidation of C175 Machine Engine Arrangements {1000}
CS44B and CP44B Vibratory Soil Compactors Fuel System Primary Filter (Water Separator) - Replace
Different Bolts for the Front Suspension Mounting Can Be Used on Certain 793 Off-Highway Trucks {7200, 7200} Different Bolts for the Front Suspension Mounting Can Be Used on Certain 793 Off-Highway Trucks {7200, 7200}
CS44B and CP44B Vibratory Soil Compactors Cooling System Pressure Cap - Clean/Replace
735C and 745C Articulated Trucks Torque Converter and Transmission Oil Filter - Replace
New Transmission Group and Yoke Are Now Used on Certain Wheel Feller Bunchers {3030} New Transmission Group and Yoke Are Now Used on Certain Wheel Feller Bunchers {3030}
AP355F Asphalt Paver Machine Systems Tow Arm - Remove and Install