Engine Air Cleaner Element (Single Element) - Inspect/Replace
Perform the Operation and Maintenance Manual, "Engine Air Cleaner Service Indicator-Inspect" procedure and perform the Operation and Maintenance Manual, "Engine Air Precleaner Check/Clean" procedure (if equipped) before performing the following procedure.
Show/hide table
| NOTICE |
|---|
|
Never run the engine without an air cleaner element installed. Never run the engine with a damaged air cleaner element. Do not use air cleaner elements with damaged pleats, gaskets or seals. Dirt entering the engine causes premature wear and damage to engine components. Air cleaner elements help to prevent airborne debris from entering the air inlet. |
Show/hide table
| NOTICE |
|---|
|
Never service the air cleaner element with the engine running since this will allow dirt to enter the engine. |
Show/hide table
| |
| Illustration 1 | g00310663 |
Show/hide table
| |
| Illustration 2 | g00310664 |
- Remove the air cleaner cover (1) and remove the element (2).
- Seal the turbocharger air inlet (3) so that debris cannot enter the air inlet. Tape or a clean cloth can be used to cover the opening.
- Clean the inside of the air cleaner cover. Clean the body that holds the air cleaner element.
- Inspect the replacement element for the following items:damage, dirt and debris.
- Remove the seal from the opening of the turbocharger inlet.
- Install a clean, undamaged element.
- Install the air cleaner cover (1).
- Reset the service indicator.
Caterpillar Information System:
G3500 Engines Actuator Control Linkage - Lubricate
Service Replacement Of The 9Y-1784 Pyrometer Or The 7E-0870 Digital Pyrometer With The 133-6333 Pyrometer Or The 133-6334 Pyrometer {0776} Service Replacement Of The 9Y-1784 Pyrometer Or The 7E-0870 Digital Pyrometer With The 133-6333 Pyrometer Or The 133-6334 Pyrometer {0776}
G3500 Engines Alarms and Shutoffs
Electronic Modular Control Panel II (EMCP II) For MUI Engines EMCP Electronic Control (Generator Set)
G3500 Engines Governors and Actuators
Electronic Modular Control Panel II (EMCP II) For MUI Engines Component Location
G3500 Engines Sensors and Electrical Components
3500 Generator Sets Gauges and Indicators
Electronic Modular Control Panel II (EMCP II) For MUI Engines Hourmeter Programming OP7
G3500 Engines Performance Parameters
3508, 3512, and 3516 Generator Sets Model View Illustrations
3306B Industrial Engine Fuel Control Linkage - Check/Lubricate
G3500 Engines Aftercooler Condensation - Drain
G3612 and G3616 Engines Crankcase Blowby - Measure/Record
G3300 Engines Control Panel - Inspect
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Window Wiper - Inspect/Replace
3618 Engine Water Pump
G3300 Engines Carburetor Air/Fuel Ratio - Check/Adjust
3618 Engine Connecting Rod and Main Bearing Journals
3054B Industrial Engine Cooling System
784C and 785C Off-Highway Truck/Tractors Dumping with Engine Stopped
3618 Engine Engine Support
Electronic Modular Control Panel II (EMCP II) Instrument Panel
3512 Industrial Engine Cooling System Coolant Level - Check