Cylinder Block Cover Group
Show/hide table
 | |
| 图 1 | g01522094 |
发动机左视图 (3) 盖 | |
(2) 安装密封垫，使圆珠面向盖。
注: 将 1U-8846 密封垫密封胶 涂抹到盖的密封垫表面上。 使密封胶沿端盖表面和螺栓孔四周均匀分布。 端盖必须在 10 分钟内安装和上紧。
(4) 沿每个盖的底排螺栓使用 12 个隔套。
(5) 将衬套安装到六个位置 (1) 处。
Show/hide table
 | |
| 图 2 | g01160766 |
按照图 2 中所示的数字顺序将每个盖上的螺栓 1 到 8 上紧到标准扭矩。
按照图 2 中所示的数字顺序将每个盖上的螺栓 1 到 8 重新上紧到标准扭矩。
Caterpillar Information System:
3126B Engine for Caterpillar Built Machines Front Housing and Covers
3126B Engine for Caterpillar Built Machines Piston Cooling Jet
G3606 and G3608 Engines Test Tools for the Electrical System
G3612 and G3616 Engines Engine Oil Level - Check
3126B Engine for Caterpillar Built Machines Piston and Rings
3406E Truck Engines Lubrication System
3126B Marine Engine Connecting Rod
3126B Engine for Caterpillar Built Machines Connecting Rod Bearing Journal
G3612 and G3616 Engines Manual Stop Procedure
3126B and 3126E Truck Engines Crankshaft Pulley
3126B Engine for Caterpillar Built Machines Crankshaft
Removal And Installation Instructions For The HEUI Injector{1290} Removal And Installation Instructions For The HEUI Injector{1290}
3208 Marine Engine Magnetic Pickups - Clean/Inspect
G3612 and G3616 Engines Turbocharger - Clean - Cleaning with Dry Particles
3500B Engines for Caterpillar Built Power Modules Camshaft
G3612 and G3616 Engines Turbocharger - Inspect
3126B Engine for Caterpillar Built Machines Flywheel
3126B Engine for Caterpillar Built Machines Flywheel Housing
G3612 and G3616 Engines Air Inlet And Exhaust System
Installation Procedure For The Caterpillar Ignition System (CIS) On The G3608 Engine{1550} Installation Procedure For The Caterpillar Ignition System (CIS) On The G3608 Engine{1550}
Installation of the Caterpillar Ignition System (CIS) on G3606 and G3608 Engines{1550} Installation of the Caterpillar Ignition System (CIS) on G3606 and G3608 Engines{1550}
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Engine to Transmission Adapter
3126B Engine for Caterpillar Built Machines Gear Group (Front)
3500B Locomotive Engines Air Inlet and Exhaust Lines