2012/09/25 Caterpillar


New Automation Electronic Control Module Now Available for MINEGEM and Cat® Command for Underground Equipped Machines {7610}

Usage:

- MXX
Machine Control and Guidance Products:
MINEGEM (S/N: MXX1-UP)
Command (S/N: MXY1-UP)

Description of Change: An improved 437-0440 Electronic Control Mounting Gp is now available. The 437-0440 Electronic Control Mounting Gp is an improvement on the 324-2277 Electronic Control Gp .

Adaptable To: The 437-0440 Electronic Control Mounting Gp is a replacement for the 324-2277 Electronic Control Gp.

Table 1
New Part Number     Description     Former Part Number    
437-0440     Electronic Control Mounting Gp     324-2277    
When installing 437-0440 Electronic Control Mounting Gp, the Automation ECM software must be checked. Refer to Special Instruction, REHS5893, "Procedure to Check and Flash Automation ECM Software on Cat® Command for Underground Equipped Machines".

Caterpillar Information System:

2012/09/27 New Lift Arm Grease Track Protection Bar Installation Procedure Now Available for Certain Load Haul Dump Machines {6107, 7510}
2013/09/27 A New Retainer Is Now Used in the Differential Group on 793D and 793F Off-Highway Trucks {3256, 3258, 3281}
2013/04/03 A New Seal Assembly for the Differential and Bevel Gear Group Is Now Used on Certain 793 Off-Highway Trucks {3256, 3258, 3281, 7555}
559C and 579C Knuckleboom Loaders Boom Cylinder
2012/09/19 Improved Debris Protection Is Now Used For The Tilt Position Sensor On Certain Compact Track Loaders And Skid Steer Loaders {1408, 6129}
2012/09/11 The Circle Manufacturing Process Has Been Improved on Certain Motor Graders {6154}
2012/09/21 New O-Ring Seal Is Now Used in the Lift Cylinder Group for 16M Motor Graders {5102}
559C and 579C Knuckleboom Loaders Stick Cylinder
2013/09/02 A New Drawbar Group is Now Used on Certain 16M Motor Graders {6153}
770G and 772G Off-Highway Truck/Tractors Alarm - Test
C175-16 and C175-20 Locomotive Engines Engine Oil and Water Pump Drive - Install
2012/09/13 New Tamper Wear Bar Now Being Used on the AS4252C Series Screed with Certain Asphalt Pavers {6656}
Alternator - Bosch K1/N1 Capacitor - Test
2013/04/30 A New Scraper Spring Is Now Used for Certain Paving Products {6607}
2012/11/27 Improved Conveyor Flashing and Retainer Plates Are Now Used on Certain Cold Planers {6620}
Alternator - Bosch K1/N1 Stator - Test
770G and 772G Off-Highway Trucks TA2 Technical Inspection {0372, 1000, 7000, 753T, 7565} 770G and 772G Off-Highway Trucks TA2 Technical Inspection {0372, 1000, 7000, 753T, 7565}
Alternator - Bosch K1/N1 Field Winding - Test
Health Interface Module Setup and Configuration Guide System Setup
559C and 579C Knuckleboom Loaders Stabilizer Cylinder
CB44B Vibratory Asphalt Compactor Propel System Speed Sensor (Propel Motor) - Test - Solid Drum
793F AC Off-Highway Truck Hydraulic Fan and Steering System Accumulator (Steering) - Test and Charge
CB44B Vibratory Asphalt Compactor Propel System Pump Control (Electronic Displacement Control) Neutral - Test and Adjust - Split Drum
VIMSpc Update Release Information{0785, 7601} VIMSpc Update Release Information{0785, 7601}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.