C175-16 Locomotive Engine Caterpillar


Coolant Contains Fuel

Usage:

C175-16 3A9

可能原因

  • 喷油器套筒或喷油器套筒密封

建议的措施

------ WARNING! ------

热的冷却液、蒸汽和碱会造成人身伤害。

在工作温度下,发动机冷却液是热的而且处在压力下。 散热器和所有到加热器的管路或发动机中都有热的冷却液或蒸汽。 与它们的任何接触都会造成严重烫伤。

只有当发动机停机且散热器盖已经冷却到可以徒手触摸时,再慢慢拆下过滤器盖以释放压力。

冷却系统调节器含碱。 应避免它与皮肤和眼睛接触。


表 1
故障诊断与排除测试步骤  数值  结果 

1. 检查喷油器套筒或喷油器套筒密封

A. 拆下阀室盖。

B. 从缸盖上拆下喷油器。 有关详细信息,参考拆解和装配手册。

C. 对冷却系统加压以识别泄漏的喷油器套筒。

注:测试期间,请勿让冷却系统上的压力超过 103 kPa (15 psi)。 施加过高压力可能会导致冷却系统损坏。

详情请参阅系统操作 / 测试与调整手册。
 

泄漏
 

结果:喷油器套筒和喷油器套筒密封正常

结果:喷油器套筒和喷油器套筒密封不正常

修理:拆下泄漏的喷油器套筒。 仔细检查套筒是否损坏。 如果喷油器套筒上有可见的损坏迹象,更换套筒。 更换喷油器套筒的 O 形密封圈并重新安装套筒。 更换任何损坏的部件。

注:冷却液也有可能污染燃油系统。 发动机停机后,冷却系统中滞留的压力可能导致冷却液流入燃油系统。 肉眼检查燃油箱中有无冷却液。 冷却液污染燃油系统可能导致喷油器和其他燃油系统部件损坏。

确认故障已排除。
 

Caterpillar Information System:

725C2 Articulated Truck Transfer Gear Oil Filter - Replace
16M Motor Grader Ladder - If Equipped
725C2 Articulated Truck Transfer Gear Oil - Change
General Reuse and Salvage Guideline for Hydraulic Piston Pumps and Motors {5058, 5070} General Reuse and Salvage Guideline for Hydraulic Piston Pumps and Motors {5058, 5070}
777G Off-Highway Truck Engine Supplement Clean Emissions Module - Remove and Install
CP56B, CP68B, CS56B, CS66B and CS68B Vibratory Soil Compactors Machine Systems Solenoid Valve (Blade Control) - Test
CP56B, CP68B, CS56B, CS66B and CS68B Vibratory Soil Compactors Machine Systems Line Relief Valve (Leveling Blade) - Test and Adjust
C175-16 Locomotive Engine Fuel Injector
CD44B and CD54B Vibratory Asphalt Compactors Propel System Brake and Shift Lines
CD44B and CD54B Vibratory Asphalt Compactors Propel System Drum Installation Group
CD44B and CD54B Vibratory Asphalt Compactors Propel System Drum Installation Group
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Position Sensor (Left Brake Pedal)
416F, 420F, 422F, 428F, 430F, 432F, 434F and 444F Backhoe Loaders Power Train Axle Housing (Service Brakes, Differential and Bevel Gear) - Disassemble
725C2 Articulated Truck Plate Locations and Film Locations
2012/03/15 Improved Material Is Used for the CAT Film and Hydraulic Test Points Film On Certain Articulated Trucks {7405, 7557, 7563}
3516B Generator Set Engines with Dynamic Gas Blending Coolant Contains Oil
416F, 420F, 422F, 428F, 430F, 432F, 434F and 444F Backhoe Loaders Power Train Axle Housing (Service Brakes, Differential and Bevel Gear) - Assemble
CP56B, CP68B, CS56B, CS66B and CS68B Vibratory Soil Compactors Propel System Relief Valve (Main, Axle Propel Pump) - Test and Adjust
Cat® Grade Control for Soil Compactors Safety Messages
CP56B, CP68B, CS56B, CS66B and CS68B Vibratory Soil Compactors Propel System Relief Valve (Charge) - Test and Adjust
Cat® Grade Control for Soil Compactors General Information
725C2 Articulated Truck Fuel System Third Filter - Replace
Procedure to Update the Engine Damper and Related Components on C18 Machine Engines For 24M Motor Graders{1205, 1901, 1920} Procedure to Update the Engine Damper and Related Components on C18 Machine Engines For 24M Motor Graders{1205, 1901, 1920}
3516B Generator Set Engines with Dynamic Gas Blending Alternator Problem - Charging Problem and/or Noisy Operation
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.