Usage:
Typical Illustration
NOTE: Put a small amount of clean engine oil or glycerin on the lip of seal (4) and in the bores for the O-ring seals at assembly.
(1) Distance bearing is installed below pipe surface ... 0.25 ± 0.25 mm (.010 ± .010 in)
(2) Diameter of shaft ... 15.80 ± 0.03 mm (.622 ± .001 in)
Bore in bearings ... 15.88 mm (.625 in)
Bore in pipe for bearings ... 18.263 ± 0.013 mm (.7190 ± .0005 in)
(3) Valve assembly shown in the "run" (open) position.
When the valve is closed a 0.08 mm (.003 in) feeler gauge must not fit between the valve and the bore in the pipe at any point.
(4) Seal. Install the seal with the tip of the seal toward the outside as shown.
(5) Diameter of shaft ... 9.60 ± 0.03 mm (.378 ± .001 in)
Bore in the bearing ... 9.80 ± 0.03 mm (.386 ± .001 in)
NOTE: Adjust shaft as needed to change spring tension until hold-in current consumption (draw) is less than 2A at shutdown.
(6) 3N9106 Torsion Spring:
Free length ... 63.5 mm (2.50 in)
Outside diameter ... 30.7 mm (1.21 in)
(6) 108-2858 Torsion Spring:
Free length ... 54.5 ± 0.5 mm (2.15 ± .02 in)
Outside diameter ... 30.36 ± 0.50 mm (1.195 ± .020 in)
(7) 3N7848 Spring:
Length under test force ... 22.86 ± 0.50 mm (.900 ± .020 in)
Test force ... 4 N (1 lb)
Free length after test ... 35.6 ± 0.5 mm (1.40 ± .02 in)
Outside diameter ... 18.8 ± 0.5 mm (.74 ± .02 in)
(8) Bracket assembly. Bracket assembly must be adjusted so valve assembly (3) is parallel to pipe bore within 2 degrees.
(9) 4N3889 Solenoid:
Voltage rating ... 12V
Current consumption (draw):
Pull-in windings ... 53.7A at 14.4V
Hold-in windings ... 1.22A at 14.4V
4N3890 Solenoid:
Voltage rating ... 24 or 32V
Current consumption (draw):
Pull-in windings ... 39.1A at 38.4V
Hold-in windings ... .58A at 38.4V
Plunger travel ... 11.7 ± 0.3 mm (.46 ± .01 in)
Distance from plunger face to flange face:
with solenoid energized* ... 9.6 ± 0.5 mm (.38 ± .02 in)
with plunger extended ... 21.28 ± 0.13 mm (.838 ± .005 in)
*The hold-in current consumption (draw) on engine must take less than 2A at shutdown.
(10) Diode assembly. Diode assembly required to suppress the back EMF voltage spike generated when the solenoid is turned off.