Note: The truck body or the water tank should be empty and lowered before lifting the machine.
Note: Any tooling that is used for lifting the machine or for securing the machine in the raised position should only be used on a concrete surface that is capable of supporting the weight of the machine.
Illustration 1 | g01329517 |
Typical example of right front |
In order to lift the front of each side of the machine, use suitable tooling that can be mechanically secured in the raised position (25 ton minimum capacity). Place this tooling under the flat surface on the bottom of the casting which is used to mount the front suspension cylinder. The tooling should be placed near the welded joint between the casting and the front frame crossmember that is under the engine.
In order to secure the front suspension cylinder on each side of the machine, use suitable tooling that can be mechanically secured in the raised position (10 ton minimum capacity). Place this tooling under the front suspension cylinder in order to prevent the extension of the cylinder.
Illustration 2 | g01329619 |
Typical example of right rear (bottom view) |
In order to lift the rear of each side of the machine, use suitable tooling that can be mechanically secured in the raised position (25 ton minimum capacity). Place this tooling under a flat surface on the bottom of the differential housing.
Note: Do not attempt to lift the rear of the machine between the two rear suspension cylinders.