Valve Guides
Usage:
Remove Valve Guides
Start By:
a. remove valves
1. Use tool (A) and a hammer to push the valve guides out of the cylinder head as shown.
Install Valve Guides
1. Put clean engine oil on the outside diameter of the valve guides.
2. Use tooling (A), and install the valve guides until they extend 26.00 ± 2.00 mm (1.024 ± .079 in.) from the surface of the cylinder head. See Specifications for the correct values for the inside diameters of new and used valve guides.
End By:
a. install valves
Caterpillar Information System:
3516 MARINE ENGINE Valve Seat Inserts
3516 MARINE ENGINE Bridge Dowels
3516 MARINE ENGINE Valve Lifters
3516 MARINE ENGINE Valves
3516 MARINE ENGINE Piston Cooling Jets
3516 MARINE ENGINE Cylinder Head Assemblies
3516 MARINE ENGINE Fuel Injection Control Linkage
3516 MARINE ENGINE Fuel Injectors
3516 MARINE ENGINE Rocker Shaft Assemblies
3516 MARINE ENGINE Rocker Shaft Assemblies And Push Rods
3516 MARINE ENGINE Valve Covers
3516 MARINE ENGINE Flywheel Housing
3516 MARINE ENGINE Connecting Rod Bearings
3516 MARINE ENGINE Rear Gear Group
3516 MARINE ENGINE Spacer Plates
3516 MARINE ENGINE Crankshaft Main Bearings
3516 MARINE ENGINE Piston And Connecting Rod Assemblies
3516 MARINE ENGINE Cylinder Liners
3516 MARINE ENGINE Camshafts
3516 MARINE ENGINE Camshaft Bearings
MODEL MG 5050 MARINE TRANSMISSION Marine Transmission
MODEL MG 5050 MARINE TRANSMISSION Systems Operation
MODEL MG 5050 MARINE TRANSMISSION Introduction
MODEL MG 5050 MARINE TRANSMISSION Introduction