Removal Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 6V-2082 | Lifting Hook | 1 |
Start By:
- Tilt the cab, if equipped. Refer to Disassembly and Assembly, "Cab - Tilt".
- Tilt the operator platform, if equipped. Refer to Disassembly and Assembly, "Operator Platform - Tilt".
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
- Disconnect hose assemblies (1), (2), and (3) from vibratory pump (4) .
 | |
| Illustration 1 | g01369383 |
- Disconnect harness assemblies (5) and (6) .
 | |
| Illustration 2 | g01369384 |
- Disconnect hose assembly (7) .
 | |
| Illustration 3 | g01369385 |
- Disconnect hose assembly (8) .
 | |
| Illustration 4 | g01369393 |
- Attach a suitable lifting device and Tooling (A) to vibratory pump (4). The weight of vibratory pump (4) is approximately 40 kg (88 lb).
 | |
| Illustration 5 | g01369395 |
- Remove bolts (9) and vibratory pump (4) .
 | |
| Illustration 6 | g01369381 |