Drop Arm - Install
Installation Procedure
- Attach a suitable lifting device to drop arm (4) . The weight of drop arm (4) is approximately 53 kg (117 lb). Install drop arm (4) .
Show/hide table
Illustration 1 | g01304697 |
- Install pivot pin (6) and bolt (5) into drop arm (4) .
Show/hide table
Illustration 2 | g01304690 |
- Tighten bolt (3) so that a 556 ± 22 N (125 ± 5 lb) force is required through location (X) to cause motion between the pivot pin and the drop arm. Bend the tab over in order to secure bolt (3) .
Show/hide table
Illustration 3 | g01304695 |
Show/hide table
Illustration 4 | g02154457 |
- Install cover plate (1) and bolts (2) .
Show/hide table
Illustration 5 | g01304701 |
End By: Install thickness control. Refer to Disassembly and Assembly, "Thickness Control - Install".
Caterpillar Information System:
AS3301C Asphalt Screed Drop Arm - Assemble
AS3301C Asphalt Screed Drop Arm - Disassemble
793D Off-Highway Truck Jacking Locations
AS3301C Asphalt Screed Drop Arm - Remove
C9 Engines for Motor Graders Sensor Signal (Analog, Passive) - Test
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes VREF-A Error IQAN Lx A0
G3600 Engines ECM Software - Install
AS3251C Asphalt Paver Chain (Crown) - Remove and Install
450E Backhoe Loader Hydraulic and Steering System Hydraulic Hand Control (Backhoe)
2006/11/27 An Updated Gasket for the Water Temperature Regulator Housing is Available {1355, 1380, 1393}
2006/11/27 An Updated Gasket for the Water Temperature Regulator Housing is Available {1355, 1380, 1393}
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Signal (Analog, Active) - Test
AS3251C Asphalt Paver Platform - Remove and Install
AS3251C Asphalt Paver Screed - Remove and Install
AS3251C Asphalt Paver Thickness Control - Remove
AS3301C Asphalt Screed Thickness Control - Disassemble
AS3301C Asphalt Screed Thickness Control - Assemble
AS3251C Asphalt Paver Thickness Control - Install
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3304B and G3306B Engines Valve Lash Is Excessive
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes VREF-A Error IQAN Lx A1
2006/10/23 New Relief Valves Are Used in the Main Control Valve {5051, 5069}
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Module is Off-Line IQAN Lx A0