Vacuum Pump - Remove and Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
注: 为便于安装,在所有软管、软管组件及管组件上做出识别标记。 塞住所有软管组件和管组件。 这将有助于防止液体泄漏和防止污染物进入系统。
- 从真空泵 (1) 及缸体上卸下管组件 (4)。
- 从真空泵的接头 (3) 上断开真空管。
- 拆下螺栓 (2)。 从前壳体上卸下真空泵 (1)。
- 拆下垫片。
Show/hide table
图 1 | g01254510 |
典型实例 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 确保真空泵清洁、无损坏。 如有必要,更换真空泵。
- 清洁前壳体的表面。
- 将新垫片安装到真空泵 (1) 上。
- 将真空泵 (1) 安装到前壳体上。 如有必要,转动真空泵的轴来对齐齿轮。
- 安装螺栓 (2)。
拧紧 M8 螺栓至扭矩为
22 N·m (16 lb ft) 。拧紧 M10 螺栓至扭矩为
44 N·m (32 lb ft) 。 - 将真空管路连接到接头 (3) 上。
- 将管组件 (4) 安装到真空泵 (1) 及缸体上。 拧紧管组件上的螺母至扭矩为
9 N·m (80 lb in) 。
Show/hide table
图 2 | g01254510 |
典型实例 |
Caterpillar Information System:
C4.4 Industrial Engine V-Belts - Remove and Install - Engines Without an Automatic Belt Tensioner
C4.4 Engines for Caterpillar Built Machines Turbocharger - Install
C4.4 Industrial Engine Rocker Shaft and Pushrod - Remove
797B Off-Highway Truck Seat
Procedure to Install New EP Control on the Asphalt Compactors{1408, 3065, 4294, 4801, 5070, 7451} Procedure to Install New EP Control on the Asphalt Compactors{1408, 3065, 4294, 4801, 5070, 7451}
C4.4 Industrial Engine Rocker Shaft and Pushrod - Install
C4.4 Industrial Engine Rocker Shaft - Disassemble
C4.4 Industrial Engine Rocker Shaft - Assemble
C4.4 Industrial Engine Position Sensor (Fuel Injection Pump) - Remove and Install
C4.4 Industrial Engine Pistons and Connecting Rods - Remove
C4.4 Industrial Engine Pistons and Connecting Rods - Install
C4.4 Industrial Engine Pistons and Connecting Rods - Disassemble
C4.4 Industrial Engine Valve Mechanism Cover - Remove and Install
C4.4 Industrial Engine Valve Mechanism Cover Base - Remove and Install
C4.4 Industrial Engine Wastegate Solenoid - Remove and Install
C4.4 Industrial Engine Water Pump - Install
C4.4 Industrial Engine Water Pump - Remove
C4.4 Industrial Engine Water Temperature Regulator - Remove and Install
Guidelines for Effective Track Frame Guarding to Reduce Packing and Sprocket Indexing{4150} Guidelines for Effective Track Frame Guarding to Reduce Packing and Sprocket Indexing{4150}
773E, 773F, 775F, 777E, and 777F Off-Highway Truck Chassis Electronic Control System MID 087 - CID 0967 - FMI 09
773E, 773F, 775F, 777E, and 777F Off-Highway Truck Chassis Electronic Control System MID 087 - CID 0590 - FMI 14
2006/07/24 New Chassis Software Is Now Used {7620}
14M and 16M Motor Graders Braking and Hydraulic Fan System Service Brakes
R1700G Load Haul Dump Machine Systems Brake Control Valve (Parking) - Remove and Install