Axle Shaft - Remove
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 1U-5826     | 导向螺柱     | 2     |
B     | 138-7575     | 连杆支架     | 1     |
C     | 1U-8848     | 轮轴安装器     | 1     |
D     | FT1845     | 制动释放泵     | 1     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修发动机时,请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前,要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品,请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
Show/hide table
工作温度下, 传动系内的油高温高压。 热油能造成烫伤。 当发动机停运且呼吸器盖冷却到可以用手触摸时, 拆下呼吸器滤清器盖。 通过缓慢松开呼吸器滤清器盖释放油箱内的压力。 在断开传动系部件上的管线时请注意高温液压油。 |
- 将差速器中的机油排放到适当的容器中,以便存放或处置。 请参阅操作和保养手册, "差速器和终传动机油 - 更换"。
- 拆下两条螺栓 (1) 。
Show/hide table
图 1 | g01275371 |
- 安装工具 (A) 。 拆下其余螺栓 (1) 。
Show/hide table
图 2 | g01275376 |
- 使用工具 (B) 拆下盖 (2) 。 盖 (2) 的重量约为 64 kg (141 lb)。
Show/hide table
图 3 | g01275377 |
- 从盖 (3) 拆下止推垫圈 (5) 。
Show/hide table
图 4 | g01275388 |
- 拆下螺栓 (6) 以从盖 (3) 上拆下板 (7) 。
- 拆下 O 形密封圈 (4) 。 利用适当的起吊设备安装工具 (C) 。 工具 (C) 的重量约为 7 kg (15 lb)。
Show/hide table
图 5 | g01275393 |
- 利用工具 (D) 松开停车制动器。 严禁超过 4137 kPa (600 psi)。
Show/hide table
图 6 | g01275419 |
Show/hide table
图 7 | g01275422 |
- 使用适当的起吊设备拆下太阳齿轮 (8) 。 太阳齿轮 (8) 的重量约为 72 kg (159 lb)。
Show/hide table
图 8 | g01275399 |
- 卸下挡圈 (9) 。
Show/hide table
图 9 | g01275404 |
- 使用适当的起吊设备拆下太阳齿轮 (10) 。 太阳齿轮 (10) 的重量约为 27 kg (60 lb)。
Show/hide table
图 10 | g01275409 |
- 卸下轴承 (11) 。
Show/hide table
图 11 | g01275414 |
- 使用工具 (C) 和适当的起吊设备拆下轮轴 (12) 。 轮轴的重量约为 158 kg (348 lb)。
Show/hide table
图 12 | g01275434 |
Caterpillar Information System:
C175-16 Locomotive Engine Auxiliary Water Pump
773F Off-Highway Truck and 775F Quarry Truck Steering System Steering System Troubleshooting
770 and 772 Off-Highway Truck Steering System General Information
2006/05/29 Rework Procedure for Reducing Noise from Lift Cylinders {5102}
773F Off-Highway Truck and 775F Quarry Truck Hydraulic System Towing the Machine - Preparation
773F Off-Highway Truck and 775F Quarry Truck Hydraulic System Relief Valve (Hoist Raise, Hoist Lower) - Test and Adjust
RM-500 Road Reclaimer/Soil Stabilizer Machine Systems Seat - Remove and Install
RM-500 Road Reclaimer/Soil Stabilizer Machine Systems Rollover Protective Structure (ROPS) - Remove and Install
RM-500 Road Reclaimer/Soil Stabilizer Machine Systems Instrument Console (Side) - Remove and Install
RM-500 Road Reclaimer/Soil Stabilizer Machine Systems Instrument Console (Front) - Remove and Install
RM-500 Road Reclaimer/Soil Stabilizer Machine Systems Hydraulic Cylinder (Cab Slide) - Remove and Install
246C, 256C, 262C and 272C Skid Steer Loaders Daily Inspection
793D Off-Highway Truck Power Train Axle Shaft - Install
2006/06/19 New Radiator and Aftercooler Gp Now Used {1353}
Tier 1 Level Emssions Engine Repower for a 777C Off Highway Truck {1000} Tier 1 Level Emssions Engine Repower for a 777C Off Highway Truck {1000}
2006/09/11 A High Capacity Oil Filter for the Output Transfer Gear Is Used {3016, 3264}
2006/11/27 A High Capacity Oil Filter for the Output Transfer Gear Is Used {3004, 3067, 3154}
3508 EUI Engine for Off-Highway Truck/Tractors Engine Support
C7 Engine for the AP-755 Asphalt Paver and the PM-102 Cold Planer Throttle Switch Circuit - Test
Starting and Charging Systems Specifications
Starting and Charging Systems Basic Operation
CB-534D and CB-564D Asphalt Compactors Sound Information and Vibration Information
Starting and Charging Systems Test Setup A, Hookup
854K Wheel Dozer Hydraulic System Pressure Switch (Oil Filter Bypass)