 | |
| Illustration 1 | g01203224 |
This diagnostic code is associated with the AccuGrade Indicator Lamp. The FMI 03 means that the ECM has determined that the voltage of the lamp circuit is above normal.
The possible causes of this diagnostic code are listed:
- The indicator lamp has failed.
- The energize circuit of the indicator lamp is shorted to the +battery circuit.
- The ECM has failed. This is unlikely.
Note: Ensure that the diagnostic code of CID 2291 FMI 03 is active before performing this procedure.
Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE INDICATOR LAMP FOR A SHORT TO THE +BATTERY CIRCUIT.
- Turn the key start switch and the disconnect switch to the OFF position.
- Disconnect the machine harness connectors from the indicator lamp and the ECM.
- At the machine harness connector for the ECM, measure the resistance from contact J2-4 (wire N714-GY) to all contacts that are used in the machine harness connectors for the ECM.
Expected Result:
Each resistance measurement is greater than 5000 ohms.
Results:
- OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
- NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-4 (wire N714-GY) and the circuit that has a low resistance measurement.
Repair: Repair the machine harness or replace the machine harness.
STOP
Test Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE.
- Inspect the contacts and clean the contacts of the harness connectors.
- Reconnect all harness connectors.
- Turn the disconnect switch and the key start switch to the ON position.
- Operate the machine.
- Determine if the CID 2291 FMI 03 is active.
Expected Result:
The CID 2291 FMI 03 is active.
Results:
- YES - The CID 2291 FMI 03 is active. The problem has not been corrected. The ECM may have failed.
Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Module - Replace".
STOP
- NO - The CID 2291 FMI 03 is not active. The problem does not exist at this time.
Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.
STOP