950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Power Train Caterpillar

Installation Procedure

Note: Cleanliness is an important factor. Before the disassembly procedure, Thoroughly clean the exterior of the component to prevent dirt from entering the internal mechanism.

Show/hide table

Illustration 1	g01189541

1. Use a suitable lifting device to position the fixed axle under the machine, as shown. The weight of the fixed axle is approximately 1134 kg (2500 lb).
   Show/hide table

   Illustration 2	g00841243

2. Install bolts (6) and the washers that hold the fixed axle to the front loader frame. The torque for bolts (6) is 1000 ± 125 N·m (738 ± 92 lb ft).

3. Install cover (5) and bolts (4) on each side of the fixed axle.
   Show/hide table

   Illustration 3	g00841237

4. Connect hose assembly (1) to fixed axle (2).

5. Connect harness assembly (3).

6. Fill fixed axle (2) with oil. Refer to Operation and Maintenance Manual, "Refill Capacities" for the correct procedure.

End By:

1. Install the front drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Front) - Remove and Install".

2. Install the front tires and rims. Refer to Disassembly and Assembly, "Tire and Rim (Front) - Remove and Install".