- Engine: Commercial
- 3500 and 3500B Family All
The 3500 Engines have several bolted joints that use a torque turn procedure at assembly. These bolted joints include main bearing caps, cylinder heads, and crankshaft counterweights.
In order to tighten the bolts, a specific preliminary torque is applied. This is followed by a torque-turn angle that is measured in degrees. The resultant torque will vary greatly due to the following factors: properties of the material, metallurgical properties and environmental conditions. Due to these variables, tightening bolts to a specific torque would yield significantly different clamping force. In certain critical joints, a minimal variation of clamping force is important.
To ensure the proper bolt stretch and the proper clamping force, the torque turn procedure is used. As a result of this procedure, it is not possible to verify the tightness of this type of joint after assembly.
Refer to the following articles:
- Engine News, SEBD9264, "Recommended Lubrication and Torque Procedure for Main Bearing Cap Bolts"
- Engine News, SEBD9264, "Recommended Lubrication and Torque Procedure for Connecting Rod Bolts"
- Engine News, SEBD9264, "Recommended Lubrication and Torque Procedure for Crankshaft Counterweight Bolts"
- Engine News, SEBD9335, "Procedure for Cylinder Head Bolt Tightening"
- Guideline for Reusable Parts and Salvage Operations, SEBF8301, "Inspection and Reuse of Critical Fasteners Used in All Engines"