Usage:
1. Remove the cover from side of the engine block.
2. Remove bolts (1) and retainer (2).
3. Pull cooling jet (3) out of its bore in the engine block from the inside to remove it.
4. Put cooling jet (3) in position in the engine block. Make sure the oil holes in the end of the jet are toward the piston.
5. Install retainer (2) and bolts (1) to hold jet (3) in position.
6. Install the cover on the side of the engine block.
REMOVE AND INSTALL SERVICE METER
1. Remove bolts (2) and the clamps to remove service meter (1) from the tachometer drive adapter assembly.
2. Put clean engine oil on O-ring seal (3) and install service meter (1) in the tachometer drive adapter assembly. Make sure the shaft of the service meter engages in the groove (slot) in the shaft of the tachometer drive.
3. Install bolts (2) and the clamps to hold the service meter in position.