Flywheel
Usage:
Typical Illustration
(1) Flywheel shoulder.
(2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of flywheel.
NOTE: Do not heat ring gear to more than 400°F (204°C) before installing on flywheel.
(3) Pilot bore.
(4) Torque for bolts holding flywheel to crankshaft ... 90 ± 7 N·m (66 ± 5 lb ft)
Put 5P3413 Sealant on the bolt threads.
NOTE: Dash mark on flywheel must be in alignment with dash mark on crankshaft.
Caterpillar Information System:
3208 MARINE ENGINE Pulley And Damper Group
3208 MARINE ENGINE Flywheel Housing Bore
3208 MARINE ENGINE Flywheel Housing Runout
3208 MARINE ENGINE Flywheel Runout
3208 MARINE ENGINE Flywheel Housing
3208 MARINE ENGINE Bearings For Connecting Rods And Mains
3208 MARINE ENGINE Crankshaft
3208 MARINE ENGINE Crankshaft Seals
3208 MARINE ENGINE Belt Tension Chart
3208 MARINE ENGINE Pistons And Rings
3208 MARINE ENGINE Connecting Rod
3208 MARINE ENGINE Cylinder Block
3208 MARINE ENGINE Alternators And Regulators
3208 MARINE ENGINE Electric Starter Motor
3208 MARINE ENGINE Shutoff Solenoids
3208 MARINE ENGINE Systems Operation
3208 MARINE ENGINE Testing & Adjusting
3208 MARINE ENGINE ATTACHMENTS Introduction
3208 MARINE ENGINE ATTACHMENTS Indicators For Engine Oil Pressure
3208 MARINE ENGINE ATTACHMENTS Indicators For Gear Oil Pressure
3208 MARINE ENGINE ATTACHMENTS Indicators For Transmission Oil Pressure
3208 MARINE ENGINE ATTACHMENTS Sending Units For Oil Pressure
3208 MARINE ENGINE ATTACHMENTS Ammeters
3208 MARINE ENGINE ATTACHMENTS Indicators For Water Temperature