Flywheel Housing Runout
Usage:
Face Runout (Axial Eccentricity) Of The Flywheel Housing:
8T5096 Dial Indicator Group Installed
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at 0.00 mm (.000 in) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than 0.25 mm (.010 in), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
3208 MARINE ENGINE Flywheel Runout
3208 MARINE ENGINE Flywheel Housing
3208 MARINE ENGINE Bearings For Connecting Rods And Mains
3208 MARINE ENGINE Crankshaft
3208 MARINE ENGINE Crankshaft Seals
3208 MARINE ENGINE Belt Tension Chart
3208 MARINE ENGINE Pistons And Rings
3208 MARINE ENGINE Connecting Rod
3208 MARINE ENGINE Cylinder Block
3208 MARINE ENGINE Water Temperature Regulators
3208 MARINE ENGINE Water Pump
3208 MARINE ENGINE Oil Filter Group
3208 MARINE ENGINE Flywheel Housing Bore
3208 MARINE ENGINE Pulley And Damper Group
3208 MARINE ENGINE Flywheel
3208 MARINE ENGINE Alternators And Regulators
3208 MARINE ENGINE Electric Starter Motor
3208 MARINE ENGINE Shutoff Solenoids
3208 MARINE ENGINE Systems Operation
3208 MARINE ENGINE Testing & Adjusting
3208 MARINE ENGINE ATTACHMENTS Introduction
3208 MARINE ENGINE ATTACHMENTS Indicators For Engine Oil Pressure
3208 MARINE ENGINE ATTACHMENTS Indicators For Gear Oil Pressure
3208 MARINE ENGINE ATTACHMENTS Indicators For Transmission Oil Pressure