Removal Procedure
 |
At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure. Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury. |
 |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
- Drain the engine coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
- Remove bolts (1) .
 | |
| Illustration 1 | g01052518 |
- Remove cover (2) .
- Remove bolts (3). Place bracket assembly (4) aside.
- Remove bolts (5) .
 | |
| Illustration 2 | g01052519 |
- Remove engine oil cooler assembly (6) and the gasket.
- Remove bolts (7) .
 | |
| Illustration 3 | g01052520 |
- Remove engine oil cooler (8) and the gasket.
Installation Procedure
- Install engine oil cooler (8) and the gasket.
| | |
| Illustration 4 | g01052520 |
- Install bolts (7) .
- Install engine oil cooler assembly (6) and the gasket.
| | |
| Illustration 5 | g01052519 |
- Install bolts (5) .
- Install bracket assembly (4) with bolts (3) .
| | |
| Illustration 6 | g01052518 |
- Install cover (2) .
- Install bolts (1) .
- Fill the engine coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check" and Operation and Maintenance Manual, "Capacities (Refill)".