C15 and C18 Engines for Caterpillar Built Machines Caterpillar


Turbocharger - Assemble

Usage:

631E 1AB

组装步骤


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。



注意

压缩机壳体必须在涡轮增压器组件上保持平直不倾斜。 倾斜可能会导致压缩机叶片倾翻或导致压缩机轴损坏。





    图 1g02562280

  1. 将盖 (8) 和密封垫(未显示)放置到位。 安装螺栓 (7) 并用手拧紧。 将螺栓 (7) 拧紧至扭矩为 25 ± 6 N·m (18 ± 4 lb ft)。 将螺栓 (7) 拧紧到 47 ± 9 N·m (35 ± 6 lb ft) 的最终扭矩。 对所有其他盖重复此步骤。

  1. 将压缩机壳体 (5) 和涡轮壳体 (1) 放置到涡轮增压器芯 (3) 上。

    注: 确保配合面平整。

  1. 拧紧 V 形带箍 (2) 上的螺母至扭矩为 17 ± 1 N·m (124 ± 9 lb in)。 用软面锤轻轻敲击卡箍直径周围区域。 将螺母重新上紧到 17 ± 1 N·m (124 ± 9 lb ft) 的扭矩。

  1. 拧紧 V 形带箍 (4) 上的螺母至扭矩为 17 ± 1 N·m (124 ± 9 lb in)。 用软面锤轻轻敲击卡箍直径周围区域。 将螺母重新上紧到 17 ± 1 N·m (124 ± 9 lb ft) 的扭矩。

  1. 确保叶轮可以自由旋转。

  1. 将软管 (6) 连接到压缩机壳体上。

End By: 安装涡轮增压器。 请参阅 拆解和组装, "涡轮增压器 - 安装"。

Caterpillar Information System:

C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Disassemble
CP34 and CS34 Vibratory Soil Compactors Axle Oil Level (Rear) - Check
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Relief Valve (Main) - Test and Adjust
446D Backhoe Loader Engine Air Filter Service Indicator - Inspect
980H Wheel Loader Steering System Steering Neutralizer Valve
CP34 and CS34 Vibratory Soil Compactors Axle Oil (Rear) - Change
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Articulating and Oscillating Hitch - Install - Without Auxiliary Water Tank
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Articulating and Oscillating Hitch - Assemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Articulating and Oscillating Hitch - Disassemble
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Articulating and Oscillating Hitch - Remove - Without Auxiliary Water Tank
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Secondary Steering Pump and Electric Motor - If Equipped
CP34 and CS34 Vibratory Soil Compactors Axle Oil Sample - Obtain
R2900G Load Haul Dump Power Train Electronic Control System Solenoid Valves
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Hydraulic Tank - Remove and Install
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Hydraulic Oil Cooler - Remove and Install
CAES ULTRA Machine Control ; Guidance Products Computer Aided Earthmoving System Annunciator
CAES ULTRA Machine Control ; Guidance Products Computer Aided Earthmoving System Switches
CAES ULTRA Machine Control ; Guidance Products Computer Aided Earthmoving System Digital Terrain Model
CP-323C and CS-323C Paving Compactors Battery - Clean/Check
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
CP-323C and CS-323C Paving Compactors Battery or Battery Cable - Inspect/Replace
CP-323C and CS-323C Paving Compactors Circuit Breakers - Reset
3524B Engines for 797 and 797B Off-Highway Trucks Cold Mode Operation
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.