Glossary
The listed definitions are components used for the XQ2000.
Sync Check Relay (25) - The sync check relay (25) is a device that prevents the generator circuit breaker from electrically closing out of synchronization.
Generator Paralleling Controller - The GPC is a control device that provides synchronizing, load share, and utility base load control for the generator set.
Utility Multifunction Relay - The utility multifunction relay is a protection device that provides three-phase, ground, negative sequence over current, voltage and frequency protection. The utility multifunction relay is intended for interlock applications that are covered by the "IEEE-P1547" specification.
Caterpillar Information System:
XQ Auto Paralleling Abbreviations
XQ Auto Paralleling Operator Controls
XQ Auto Paralleling Base Load Potentiometer Settings
XQ Auto Paralleling Default Settings for Utility Multifunction Relay
XQ Auto Paralleling Utility Paralleling Mode
XQ Auto Paralleling Island Paralleling Mode
XQ Auto Paralleling Single Unit Mode
XQ Auto Paralleling Fuel System
XQ Auto Paralleling Reference Material
XQ Auto Paralleling Component Location
XQ Auto Paralleling Component Descriptions
XQ Auto Paralleling General Information
C280 Marine Engines Crankshaft Deflection (Bend)
C7.1 Industrial Engine Configuration Parameters
C7.1 Marine Generator Set Electrical System
C4.4 (Mech) Marine Generator Set MCS-3 Alarms and Shutoffs
C4.4 (Mech) Marine Generator Set MCS-3 Engine Operation with Active Diagnostic Codes
Installation and Operation of the Caterpillar Diesel Particulate Filter (DPF) and the Diagnostic Module for Non-Road Machine Applications (Non-California Applications) {108F, 1091, 7490} Installation and Operation of the Caterpillar Diesel Particulate Filter (DPF) and the Diagnostic Module for Non-Road Machine Applications (Non-California Applications) {108F, 1091, 7490}
Foreword {0374, 4150, 7000, 7590, 7950} Foreword {0374, 4150, 7000, 7590, 7950}
C4.4 (Mech) Marine Generator Set MCS-3 Engine Operation with Intermittent Diagnostic Codes
C4.4 (Mech) Marine Generator Set MCS-3 Configuration Parameters - Customer Specified Parameters
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Electronic Modular Control Panel 4 (EMCP 4) - EMCP 4.3/4.4
Introduction {0374, 4150, 7000, 7590, 7950} Introduction {0374, 4150, 7000, 7590, 7950}
C9.3 Tier 4 Final Engines Diesel Particulate Filter Has Changed Regeneration Interval